- No category
advertisement
18
SERVICE
IMPORTANT:
Because many of the parts and assemblies not mentioned in this Instruction Manual are vital to the safety of the unit, and because all parts are subject to a certain amount of wear and tear, it is important for your own safety that you have the unit checked and maintained regularly by a
MAKITA service center.
IMPORTANT:
If the cutting wheel breaks during cutting, the
Power Cut must be repaired by a MAKITA service centre before being used again!
Changing the V-belt
Loosen bolts (1) and remove belt cover (2).
3
4
5
1 2
Move the V-belt pulley into the position shown.
Insert the Allen key into the hole (3) to block the V-belt pulley
(5).
Note: Make sure that the V-belt pulley remains blocked.
Use the combination tool to turn the nut (4) about one turn counter-clockwise.
Use the combination tool to turn the eccentric (6) forcefully counter-clockwise to the position shown.
Remove the old V-belt (7) or belt fragments.
Clean out the interior with a brush.
Insert a new V-belt.
Use the combination tool to turn the eccentric (6) forcefully clockwise to its original position (V-belt is now tight).
Tighten the nut (4).
Remove Allen key from hole (3).
Put the belt cover (2) on and tighten the bolts (1).
6
7
Note: The V-belt is highly elastic, so it is not necessary to retighten it.
A worn V-belt causes the cutoff disc turns at the lowest idle speed. In this case, the V-belt must be replaced!
advertisement
Related manuals
advertisement
Table of contents
- 2 Packing
- 3 Delivery inventory
- 3 Symbols
- 4 General precautions
- 4 Protective equipment
- 5 Fuels / Refuelling
- 5 Putting into operation
- 6 Cutting discs
- 7 Kickback and lock-in
- 7 Working behavior / Method of working
- 8 synthetic resin cutting discs
- 8 Cutting metal
- 8 Cutting masonry and concrete
- 9 Transport and storage
- 10 First aid
- 10 Disposal and environmental protection
- 11 Technical data
- 12 Denomination of components
- 13 Mounting the cutting disc
- 14 Fuels / Refuelling
- 16 Starting the engine
- 16 Stop engine
- 17 Adjusting the carburetor
- 18 Changing the V-belt
- 19 Cleaning the protection hood
- 19 Cleaning / changing the air Þ lter
- 20 Replacing the spark plug
- 20 Replacing the suction head
- 21 Replacing the starter cable
- 22 Replacing the return spring
- 22 Replacing the start spring
- 23 Instructions for periodic maintenance
- 23 Service, spare parts and guarantee
- 25 Troubleshooting
- 25 Diamond cutting discs, water tank
- 26 Extract from spare parts list