advertisement
2
Perform setting to reduce stripes between passes
In case that feeding stripes cannot be resolved even though media correction is performed, make “MAPS
(Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass boundary.
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes strong and feeding stripes become less visible.
• The resolutions and passes for which MAPS is enabled are shown in the following table.
• For conditions when MAPS is disabled, the printer operates with MAPS-OFF and print speed settings disabled (±0%).
• MAPS may not be effective depending on image to be printed.
• Slight color change may be found.
Resolution
(dpi)
540x720
540x1080
720x720
720x1080
720x1440
△
2
4 colors
4
6
8
○
4
6
◎
8, 16
12, 24
8, 16
12, 24
16, 32
Pass
△
6/ 7/ 8 colors
8
12
16
○
8
12
◎
16, 32
24, 48
16, 32
24, 48
32, 64
◎ : MAPS can be used when the print speed setting is within a range of ±50%, for both high speed and standard speed.
○ : At high speed, print speed is within the range of -50% to -1%. At standard speed, MAPS can be used when the print speed is within a range of ±50%.
△ : MAPS can be used when the print speed setting is within the range of -50% to -1% at standard speed only.
4
5
6
7
1
2
3
Press the
Press the
Press the
Press
Press the
key in LOCAL.
key.
key.
to select [MAPS].
key.
Press to set ON/OFF.
• Set Value : OFF, ON
Press the key.
• When you select OFF, proceed to the Step 9.
FUNCT I ON
SE TUP
SE TUP
SE L ECT
[ 1 ]
MED I A COMP .
[ 1 ]
MAPS
[ 1 ] MAPS
SE TUP
[ 1 ] MAPS
SE TUP
[ 1 ] MAPS
PR I NT SPEED
< ENT >
: T YPE . 1
< e n t >
< e n t >
: OF F
: ON
: 0%
Perform setting to reduce stripes between passes
8 Press to change print speed.
• Set Value : -50 ~ +50%
(If +20% is entered, the print speed increases by approximately 20%. If -20% is entered, the print speed decreases by approximately 20%.)
9 Press the
10 Press the
key.
key several times to end the setting.
[ 1 ] MAPS
PR I NT SPEED
[ 1 ]
MAPS
: 1 0%
< e n t >
3
advertisement
Related manuals
advertisement