advertisement
User’s Manual of OWON Colour Digital Storage Oscilloscope
Appendix D: Battery Using Guide
Charging the oscilloscope
The lithium battery maybe not be charged when delivery. Please charge the battery for 12 hours to make sure enough power to supply (the oscilloscope should be turned on during charging) to oscilloscope. The battery can supply power for 4 hours after being charged completely.
There will have battery power indication show on the top of panel when oscilloscope power supplied by the battery. , , and imply for different power consumption and when shows it means the power can only supply for 5 minutes maximum.
Note:
To avoid superheat of battery during charging, the environment temperature is not allowed to exceed the permissible value given in technical specification.
Replacing the Lithium Battery Unit
It is usually not required to replace the battery unit. But when it is required to replace it, only qualified personnel can carry out this operation, and only use the same specification lithium battery
80
advertisement
Related manuals
advertisement
Table of contents
- 12 Introduction to the Front Panel and the User's Interface of the PDS series Oscilloscope
- 16 How to Carry on the General Inspection
- 17 How to Carry on the Function Inspection
- 19 How to Implement the Probe Compensation
- 20 How to Set the Probe Attenuation Coefficient
- 21 How to Use the Probe Safely
- 22 How to Implement Auto-calibration
- 23 Introduction to the Vertical System
- 24 Introduction to the Horizontal System
- 25 Introduction to the Trigger System
- 26 Advanced User's Guidebook
- 27 How to Set the Vertical System
- 33 Implementation of Mathematical Manipulation Function
- 34 Application of VERTICAL POSITION and VOLTS/DIV Knobs
- 35 How to Set the Horizontal system
- 36 Main Time Base
- 37 Window Setting
- 38 Window Expansion
- 39 How to Set the Trigger System
- 40 Trigger Control
- 40 Edge Trigger
- 43 Video Trigger
- 46 How to Operate the Function Menu
- 46 How to Implement Sampling Setup
- 49 How to Set the Display System
- 51 Persist
- 51 XY Format
- 53 How to Save and Recall a Wave Form
- 54 Save and Recall the Wave Form
- 55 How to Carry on the Auxiliary System Function Setting
- 56 Do Self Cal (Self-Calibration)
- 56 SYS STAT (System State)
- 58 How to Conduct the Automatic Measurement
- 58 Measure
- 60 How to Carry on the Cursor Measurement
- 61 Cursor Measurement
- 63 How to Use Executive Buttons
- 63 AUTOSET
- 64 Examples of Application
- 64 Example 1: Measurement of Simple Signals
- 65 Example 2: Gain of the Amplifier in the Metering Circuit
- 66 Example 3: Capture the Single Signal
- 68 Example 4: Analyze the Details of a Signal
- 70 Example 5: Application of X-Y Function
- 71 Example 6: Video Signal Trigger
- 74 Fault Treatment
- 75 Appendix A: Technical Specifications
- 79 Appendix B: Enclosure
- 79 Appendix C: Maintenance, Cleaning and Repairing
- 80 Appendix D: Battery Using Guide