Program selection
Program selection
Functional description
An electronic sensor system monitors the moisture content of the laundry.
Once the required degree of dryness is reached, cold air then enters the drum to cool the laundry.
The drying program is then terminated.
– Load size - Full / Half
To dry a standard size load of 2,3 kg or more at peak efficiency, press this button before starting the drying cycle.
– Start
Starts the selected program.
Function of the pushbuttons
“PROGRAM SEQUENCE” indicator
The program sequence indicator lamps show the current status of the drying program.
“DRYING STAGE REACHED” indicator
This indicator shows which drying stage the program has reached.
– Door
This button is used to open the door.
– ON/OFF
When the machine is turned on, the
“On” indicator lamp illuminates when the door is closed. When the door is open, the drum is illuminated.
– Buzzer
When activated, the buzzer will sound as the drum rotates during the anticrease cycle.
“PROGRAM SETTING” selector
There is a range of settings for both
“Cottons” and “Permanent Press”.
In addition, items can be either dried for 20 minutes (incl. a cooling-down phase lasting 8 mins.) or fluffed in cool air for 15 minutes.
10
Program selection
To select a program
A program can only be selected when the machine is turned on.
Set the desired program by turning the program selector either clockwise or counterclockwise.
Press the “Start” button.
The program status will be stored for
30 minutes in the event of a power failure.
The program is cancelled if
– There is a power failure lasting more than 30 minutes.
– The program has already reached the “Cooling down” or “Anti-crease” stage.
To change a program during drying
Set the program selector to the desired program.
The new program will start from the beginning.
The tables on the following pages lists the range of applications for the different programs.
Correct procedure
1 Press the “On/Off” button.
2 Press the “Door” button and load the drum.
3 Close the door with a firm swing - do not push it shut.
4 If drying a standard load, press the
"Load size" button.
5 Select a program.
6 Press the “Start” button.
After the program has finished
1 Set the program selector to “Finish”.
2 Remove the laundry.
3 Clean the lint filter.
4 Turn off the machine.
11