- Home
- Do-It-Yourself tools
- Garden tools
- Grass trimmers
- Qualcast
- 1600W HOVER N TRIMMER
- Instruction manual
Winding New Line onto a Spool. Qualcast 1600W HOVER N TRIMMER, MEH1633+GT2551
Add to My manuals18 Pages
advertisement
9
Maintenance
Winding New Line onto a Spool
5
4
10
6
• You may wind new cutting line onto an empty spool. Use 1.5mm line
• Remove the empty spool from the tool as described above.
• Remove any remaining cutting line from the spool.
• First feed 10 cm of cutting line 4 into each of the two eyelets, one eyelet 5 in the upper section of the spool as shown, the other eyelet in the lower section not shown, but still proceeding in the same manner as shown for the upper section.
• Wind the cutting line onto the spool in the direction of the arrow 6 . Make sure to wind the line on neatly and in layers. Do not criss-cross.
• Lock the cutting line into a slot on the edge of spool.
• Insert the spool into the cutter head assembly as described above. Do not forget to release the cutting line from the slot on the edge of the spool and tread it through the eylets in the housing
(see- Fitting a New Spool).
WARNING !
Only use the appropriate type of cutting line.
Customer Helpline 0345 640 0800 15 16
advertisement
Related manuals
advertisement
Table of contents
- 3 Safety Information
- 3 Warnings Symbols
- 4 Safety Warning
- 7 Precautionary Measures
- 10 In the Box
- 10 Parts
- 11 Assembly
- 11 Step 1 - Assembling the Housing and Handle
- 11 Step 2 - Fitting the Guard
- 12 Operating Instructions & Tips
- 12 Extension Lead
- 13 Starting and Stopping
- 13 Cutting
- 14 Maintenance
- 14 Fitting a New Spool of Cutting Line
- 15 Winding New Line onto a Spool
- 16 Spool Storage
- 18 Troubleshooting
- 18 General Troubleshooting
- 18 Technical Data
- 18 Technical Data Table
- 18 Disposal
- 18 Disposal and Recycling
- 18 Getting Help