Securing your computer. Acer Aspire Switch 10 V - SW5-014

38 - Securing your computer

S

ECURING YOUR COMPUTER

Your computer is a valuable investment that you need to take care of.

Learn how to protect and take care of your computer.

Using passwords

Passwords protect your computer from unauthorized access. Setting these passwords creates several different levels of protection for your computer and data:

• Supervisor Password prevents unauthorized entry into the BIOS utility. Once set, you must enter this password to gain access to the

BIOS utility.

See Setting passwords on page 40

.

• User Password secures your computer against unauthorized use.

Combine the use of this password with password checkpoints on boot-up and resume from Hibernation (if available) for maximum security.

• Password on Boot secures your computer against unauthorized use. Combine the use of this password with password checkpoints on boot-up and resume from Hibernation (if available) for maximum security.

Important

Do not forget your Supervisor Password! If you forget your password, please get in touch with your dealer or an authorized service center.

Entering passwords

When a password is set, a password prompt appears in the center of the display screen.

• When the Supervisor Password is set, a prompt appears when you enter the BIOS utility.

• Type the Supervisor Password and press < Enter > to access the

BIOS utility. If you enter the password incorrectly, a warning message appears. Try again and press < Enter >.

• When the User Password is set and the password on boot parameter is enabled, a prompt appears at boot-up.

Securing your computer - 39

• Type the User Password and press < Enter > to use the computer. If you enter the password incorrectly, a warning message appears. Try again and press < Enter >.

Important

You have three chances to enter a password. If you fail to enter the password correctly after three tries, the system halts. Press and hold the power button for four seconds to shut down the computer. Then turn on the computer again, and try again.