PREFACE. Juki 36200UY60, 36200UJE60, 36200UX60, 36200UAE52, 36200UJ60, 36200UE60, 36200UM60, 36200UY52, 36200UE52, 36200UH52

Manual No. PT0106 llustrated Parts List for 36200 Series Machines

Second Edition Copyright 2002

By

Union Special Corporation Rights Reserved In All Countries

Printed in U.S.A. May 2002

PREFACE

This parts manual has been prepared to assist you in locating individual parts or assemblies on 36200 Series machines.

It is the desire of Union Special that each machine run at its optimum performance. Parts listed in this manual are designed specifically for your machine and are manufactured with utmost precision to assure long lasting service.

This manual has been comprised on the basis of available information. Changes in design and/or improvements may incorporate a slight modification of configuration in illustrations or part numbers.

On the following pages are illustrations and terminology used in describing the parts used on 36200 Series machines.

TERMS

Prices are net cash and subject to change without notice. All shipments are forwarded F.O.B. shipping point. A charge is made to cover postage and insurance.

CONTENTS

PREFACE .................................................................................................................................................................................................... 2

TERMS ........................................................................................................................................................................................................ 2

IDENTIFICATION OF MACHINES .............................................................................................................................................................. 3

TORQUE REQUIREMENTS ........................................................................................................................................................................... 3

DESCRIPTION OF MACHINES ................................................................................................................................................................... 3

STYLE OF MACHINES ................................................................................................................................................................................ 4

SAFETY RULES: ........................................................................................................................................................................................... 5

IDENTIFYING PARTS .................................................................................................................................................................................. 6

NEEDLES ..................................................................................................................................................................................................... 6

APPLICATION ............................................................................................................................................................................................ 6

Threading .................................................................................................................................................................................................. 7

Oiling ......................................................................................................................................................................................................... 8

ADJUSTING INSTRUCTIONS ...................................................................................................................................................................... 9

SETTING THE NEEDLE BAR HEIGHT & ALIGNMENT ................................................................................................................................... 9

SETTING THE NEEDLE BAR HEIGHT & ALIGNMENT (CONT) .................................................................................................................. 10

ALIGNING THE CYLINDER ...................................................................................................................................................................... 10

SETTING THE LOOPER TRAVEL ................................................................................................................................................................ 10

INSTRUCTIONS FOR USING SYNCHRONIZING GAUGE 21277CG ....................................................................................................... 11

SETTING THE LOOPER TRAVEL ................................................................................................................................................................ 11

TIMING THE NEEDLES TO THE LOOPER .................................................................................................................................................. 11

TIMING THE NEEDLES TO THE LOOPER (CONT.) ................................................................................................................................... 12

LOOPER ADJUSTMENTS ......................................................................................................................................................................... 13

LOOPER ADJUSTMENTS (CONT.) ........................................................................................................................................................... 14

SETTING THE FRONT NEEDLE GUARD .................................................................................................................................................... 14

SETTING THE FEED DOGS ....................................................................................................................................................................... 14

SETTING THE REAR NEEDLE GUARD ....................................................................................................................................................... 15

SETTING THE STITCH LENGTH ................................................................................................................................................................. 15

DIFFERENTIAL FEED CONTROL ............................................................................................................................................................... 15

2