SR 50

2.2.7. MIXER OIL IE50

TOPPING UP

CAUTION

The vehicle fits a control unit that manages an electronic pump controlling the correct quantity of oil for engine lubrication.

•

Remove the front cover, see (REMOVING THE

FRONT COVER).

•

Remove the plug.

• Fill with oil, see (LUBRICANT CHART)

•

Refit the plug.

AIR BLEED

CAUTION

The vehicle fits a self-bleeding electronic pump.

If the oil in the mixer oil tank is low or if the mixer oil line from the mixer to the reed assembly - is removed, it is necessary to bleed the system. Proceed as follows:

• Completely open the throttle grip.

•

Keep the throttle open, turn the key to ON.

• You will hear the noise of the pump.

•

Look at the mixer oil line going from the mixer to the reed assembly and keep the throttle completely open until the line is full of oil.

• Release the throttle twistgrip.

•

If necessary, top up with mixer oil as described above.

PERIODIC MAINTENANCE

2 - 31

SR 50

FUEL SYSTEM

FUEL SYSTEM

3

3 - 1

FUEL SYSTEM

SR 50

TABLE OF CONTENTS

3.1.

FUEL TANK ...................................................................................................................................................... 3

3.1.1.

FUEL FEED SYSTEM DIAGRAM IE361 – IE50 ........................................................................................ 3

3.1.2.

FUEL SUPPLY SYSTEM DIAGRAM C364................................................................................................ 4

3.1.3.

REMOVING THE FUEL TANK IE361 – IE50............................................................................................. 5

3.1.4.

REMOVING THE FUEL TANK C364......................................................................................................... 7

3.1.5.

REMOVING THE FUEL SENSOR............................................................................................................. 9

3.2.

AIR FILTER..................................................................................................................................................... 10

3.2.1.

REMOVING THE AIR FILTER AND THE AIR BOX IE361 - IE50............................................................ 10

3.2.2.

REMOVING THE AIR FILTER AND THE AIR BOX C364 ....................................................................... 12

3.3.

INJECTION UNIT............................................................................................................................................ 13

3.3.1.

INJECTION SYSTEM DIAGRAM IE50 .................................................................................................... 13

3.3.2.

REMOVING THE THROTTLE BODY IE361 – IE50 ................................................................................ 14

3.3.3.

REMOVING THE INJECTION UNIT IE361 – IE50 .................................................................................. 15

3.4.

CARBURETOR............................................................................................................................................... 16

3.4.1.

CARBURETOR DIAGRAM C364 ............................................................................................................ 16

3.4.2.

REMOVING THE CARBURETOR C 364................................................................................................. 17

3 - 2