advertisement
▼
Scroll to page 2
of
76
Appendix C: Vehicle Power Management Setup
Appendix C: Vehicle Power Management Setup
External Power Output Setting
External +12V and +5V Turn On Simultaneously External +12V and +5V Turn Off Simultaneously
Copyright © 2011 Nexcom International Co., Ltd. All Rights Reserved 54 VTC 6201 Series User Manual
Appendix C: Vehicle Power Management Setup
External +12V Turn On Only External +5V Turn On Only
Copyright © 2011 Nexcom International Co., Ltd. All Rights Reserved 55 VTC 6201 Series User Manual
advertisement
Related manuals
advertisement
Table of contents
- 15 Chapter 1: Product Introduction
- 15 Overview
- 15 Key Features
- 17 Hardware Specifications
- 20 Getting to Know VTC 6201 / VTC 6201-M
- 20 Front Panel
- 22 Getting to Know VTC 6201 / VTC 6201-M
- 22 Rear Panel
- 27 Chapter 2: Jumpers and Connectors
- 27 Before You Begin
- 27 Precautions
- 28 Jumper
- 29 Locations of the Jumpers and Connectors
- 31 Jumper Settings
- 31 SW4: Input Voltage Select
- 31 SW3: COM2 Port Selection (RS232/RS485)
- 31 LVDS Power Input Voltage Select (JP7)
- 31 CMOS Input Voltage Select (J4)
- 31 Temp Sensor (JP5)
- 31 PCI-104 VI/O Select Voltage (J9)
- 31 MCU Download (JP3)
- 31 GAL Download (JP2)
- 31 MCU COM Port (JP1)
- 32 Connectors
- 32 GPIO Connector
- 32 RS232 Connectors
- 33 RS485/RS232 COM2 Connector for VTC 6201/VTC 6201-M
- 34 GAL Programmer Connector
- 34 MCU Programmer Connector
- 35 LVDS Connector + USB
- 36 VGA Port
- 36 LAN Port
- 37 USB Ports
- 37 LVDS Power Connector
- 38 External 12V & 5V Power and SMBUS Connector
- 38 Mic-in Jacks
- 39 Line-out Jacks
- 39 PCI-104 VI/O Voltage Setting
- 40 PCI-104 Connector
- 40 Power Button
- 40 Reset Button
- 41 MCU COM Port
- 41 Temp Sensor
- 42 Power Input
- 42 Power On and IDE Active LED
- 43 GPIO and UMTS LEDs
- 43 SATA Ports
- 44 SATA Power Connector
- 44 SATA DOM Power Connector
- 45 Mini-PCIe Slot (3.5G)
- 45 Mini-PCIe Slot (WLAN)
- 46 GPS Connector
- 46 SIM Card Connector
- 47 Bluetooth Connector
- 48 Chapter 3: System Setup
- 48 Removing the Chassis Cover
- 49 Installing a GPRS/UMTS/HSDPA Module
- 52 Installing a Bluetooth Module
- 54 Installing the PCI-104 Module
- 56 Installing SATA Hard Drive
- 61 Installing the SODIMM
- 62 Removing the Fuse
- 63 Rackmount Brackets
- 64 Appendix A: I/O Address Function
- 64 I/O Address Function
- 67 Appendix B: VTC 6201/6201-M Main Board
- 67 VTC 6201/6201-M Specifications
- 68 Appendix C: Vehicle Power Management Setup
- 68 External Power Output Setting
- 70 Startup and Shutdown Voltage Setting
- 74 Power-on Delay Setting
- 76 Appendix D: Power Consumption
- 76 Power Consumption