Remote Trace. MCC MIIC-101

Example: E<Enter>

Remote Trace

29

Enable Simulation

Syntax: R

Description:

The Remote Trace command places the unit in POST-TRIG Trace Mode, and sends all bus traffic to the serial port.

During a Remote Trace, data in temporarily buffered in the unit, then sent to the serial port in the currently selected ASCII or Binary format. See the ASCII

Remote Select or Binary Remote Select commands for data format details.

Remote Trace terminates upon receiving a High-to-Low transition on the

External Trigger line or an Escape <Esc> character on the serial port.

Screen Pause <Ctrl-S> and Screen Resume <Ctrl-Q> are active.

Example: R<Enter> - Start Remote Trace

In the above example, bus messages are buffered and uploaded to the Host system in the selected ASCII or Binary format. See the ASCII Remote Select or

Select Address

Binary Remote Select commands for data format details.

Syntax: S(ALL | [Slave Address] )