advertisement
Installation Manual
4. Placement into service / operation
The heat pump may only be started with a full water tank!
The unit must always be disconnected from the power supply when the front cover is opened!
When the unit is disconnected, wait for the fan to stop completely before the cover is opened!
Before starting the unit makes sure all connectors are in place, and make sure the cable between display and controller is mounted correctly!
4.1 Demands to the hot water circuit
In the hot water system the following materials may be used:
- Copper
- Stainless steel
- Brass
- Plastics
Depending on the used materials in the water circuit (in the house) wrong combinations of materials may lead to corrosion damages. Special attention is required when using galvanized steel or aluminium materials.
4.2 Starting to use of the water circuit
- Fill the tank using the valve on the supply line, and let the air out through one of the upper hot tap water valves until air no longer is present in the tapped water.
- Check the entire water circuit for tightness.
- Connect the heat pump to the power supply.
After starting to use the system the entire water circuit must be checked for tightness.
4.6 Hints for energy savings
Do not set the water temperature higher than necessary.
The best utilisation of the Vanvex Lite occurs at low water temperatures.
The use of circulation will increase the energy consumption of the heat pump significantly.
4.7 Hints for fan operation
When using ductwork it may be necessary to run the fan on a higher speed to compensate for the pressure losses.
4.8 Checking
After completing installation it is advised to check all connections etc. to ensure they are tight and to check that condensate water can flow to the drain unrestricted.
For servicing please refer to user manual.
5. Service / Maintenance
For maintenance, refer to the operating instructions.
4.3 Placement into service of the water circuit
Fill the container via the connecting branch, and aerate the tank by letting one of the hot water taps located at the highest elevation within the dwelling stand open until air no longer comes out with the water.
The container can normally hold 290 litres of water.
Check the entire circuit to be sure it is sealed.
4.4 Electricity – connecting
Connect the Vanvex Lite to the public electrical grid.
4.5 The cooling circuit
The cooling circuit is delivered ready to run and no work need be performed on it. The electronic controls automatically take over all functions concerning the operation of the compressor as well as the ventilator.
If needed, set the controls to the desired water temperature.
The factory setting is 50° C (see the operating instructions for more detailed directions).
12
- Technishce Änderungen vorbehalten -
Note
- The right to make changs is reserved -
13
Note
14
- The right to make changs is reserved -
- The right to make changs is reserved -
15
Genvex World Wide:
Austria
J.Pichler Lufttechnik GmbH
A-9021 Klagenfurt
Tel.: +43 (0) 463 / 3 27 69
Fax: +43 (0) 463 / 3 75 48
E-Mail: [email protected]
Belgium
Artiklima bvba
B - 9220 Hamme
Tel.: +32 (0) 52 41 25 41
Fax: +32 (0) 52 41 29 66
E-Mail: [email protected]
Croatia
Pichler & CO d.o.o.
10000 Zagreb
Tel.: + 385/ (0) 1/ 65 45 407
Fax: + 385/ (0) 1/ 65 45 409
E-Mail: [email protected]
Denmark
Genvex A/S
DK - 6100 Haderslev
Tel.: +45 73 53 27 00
Fax: +45 73 53 27 07
E-Mail: [email protected]
Germany
Novelan GmbH
D-95359 Kasendorf
Tel.: +49 (0) 92 28 / 99 60 7-0
Fax: +49 (0) 92 28 / 99 60 7-189
E-Mail: [email protected]
Great Britain
Total Home Environment Ltd
GB- Moreton in Marsh, GL 56 0JQ
Tel.: +44 (0) 845 260 0123
Fax: +44 (0) 1608 652490
E-Mail: [email protected]
Ireland / N.I.
ECO Systems Ireland Ltd
Co. Antrim BT54 6PH
Tel.: (UK 028) (ROI 048) +44 2076 8708
Fax: (UK 028) (ROI 048) +44 2076 9781
E-Mail: [email protected]
Norway
Beam Sentralstøvsuger A/S
N - 1313 Vøyenenga
Tel.: +47 - 67 17 77 00
Fax: +47 - 67 17 77 10
E-Mail: [email protected]
Portugal
Iberterm
PT-4475-493 Nogueira Maia
Tel: +351 229 065 123/4
Fax: +351 229 065 125
E-Mail: [email protected]
Web: www.iberterm.com
Slovenia
Pichler & CO d.o.o.
2000 Maribor
Tel.: +386/ (0) 2/460 13 50
Fax: +386/ (0) 2/460 13 55
E-Mail: [email protected]
Switzerland
SM-HEAG Klimatechnik AG
CH-8307 Effretikon
Tel.: +41 (0) 52 / 355 11 00
Fax: +41 (0) 52 / 355 11 05
E-Mail: [email protected]
Intelligent ventilation appliances from
Genvex
As a ventilation specialist, our spectrum of innovative ventilation engineering solutions: From passive ventilation appliances with highly efficient counterflow heat exchangers, to machines with integral heat pumps, able to heat and cool at the lowest cost.
Ceiling appliances for retrofitting in office and residential blocks are also available.
Want to know more? Write or give us a call!
Presented by:
Published by Genvex A/S, Sverigesvej 6, DK-6100 Haderslev
www.genvex.dk
advertisement
Related manuals
advertisement
Table of contents
- 3 Refrigerant circuit – description
- 3 Cooling system - description
- 3 Electrical circuit - description
- 4 Requirements circuit
- 5 Water circuit - description
- 5 Requirements for the water circuit
- 5 Dimensions
- 8 SERVICE
- 8 Placement / set-up
- 12 Demands to the hot water circuit
- 12 Starting to use of the water circuit
- 12 Hints for energy savings
- 12 Hints for fan operation
- 12 SERVICE / MAINTENANCE