advertisement
Preparations
Charging the Battery
Pack
Checking the
Accessories
Check that you have the following items:
• Battery pack (NP-FX110) (1)
• AC power adaptor (1)
• Car battery adaptor (1)
• Audio/video cord (mini plug
×
2 y phono plug
×
3) (1)
• Remote (with battery) (1)
To replace the remote battery
When the battery becomes depleted, operation is not possible. Change the battery.
1
Prepare a new battery (lithium battery
CR2025).
2
Pull out the battery holder ( 2 ) while pressing the lock lever ( 1 ).
Charge the battery pack (supplied) before using the player for the first time, or when the battery is depleted.
1
Attach the battery pack to the player.
Align the battery pack with the lines on the bottom of the player.
Engage the hooks of the battery pack into the holes on the bottom of the player.
Battery pack
3
Remove the old battery.
4
Insert the new battery in the battery holder with the 3 side up and then push the holder until it clicks.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Attachment reference marks
Bottom of the player
Slide the battery pack in the direction of the arrow until it clicks into place.
, continued
9
10
2
Connect the AC power adaptor.
When charging begins, the CHARGE indicator lights up in orange.
POWER OFF ON
HOLD PHONES
A B
INPUT
AUDIO
IN/
OUT
VIDEO
IN/
OUT
DC IN
9.5V
To check the battery level
When the player is stopped, the battery indicator is displayed. When the battery is empty, is displayed or the CHARGE indicator flashes. Set the POWER switch to “OFF,” connect the AC power adaptor, and recharge the battery.
DC IN
9.5V
To a wall outlet
Full Empty
To remove the battery pack
Push the release knob and slide the battery pack in the direction of the arrow.
AC power Adaptor
(supplied)
When charging ends, the CHARGE indicator lights off.
Disconnect the AC power adaptor.
z
If the POWER indicator lights up instead of the
CHARGE indicator, the POWER switch is set to
“ON.” Set the POWER switch to “OFF,” and make sure that the CHARGE indicator lights up.
Release knob
Charging time and playing time
Charging time: approx. 6 hours
Playing time: approx. 6 hours
Times indicated are under the following conditions:
– Moderate temperature (20°C (68°F))
– Headphone use
– Backlight set to minimum
Depending on the ambient temperature or battery pack condition, charging time may be longer, or playing time may be reduced.
Using the Car Battery
Adaptor
After using the player in a car
1
Turn off the player.
2
Disconnect the car battery adaptor.
3
Turn off the engine.
The car battery adaptor (supplied) is for a
12V car battery, negative earth (do not use it with a 24V car battery, positive earth).
1
Start the engine.
2
Connect the car battery adaptor.
b
• Do not disconnect the car battery adaptor or turn off the car engine before you turn off the player. Doing so may damage the player.
• Disconnect the car battery adaptor after use. If it is left connected, the car battery may become depleted.
• Do not leave the player or accessories in the car.
POWER OFF ON
HOLD PHONES
A B
INPUT
AUDIO
IN/
OUT
VIDEO
IN/
OUT
DC IN
9.5V
DC IN
9.5V
To cigarette lighter socket
Car battery adaptor (supplied)
3
Turn on the player.
b
• The driver should not connect or disconnect the car battery adaptor while driving.
• Arrange the cord so as not to interfere with the driver. Also, do not place the LCD panel where the driver can watch.
• Clean the cigarette lighter socket. If it is dirty, it may cause contact failure or malfunction.
• Use the car battery adaptor with the car engine running. If it is used with the car engine off, the car battery may become depleted.
11
12
Connecting to Other
Equipment
By connecting the player to your TV or other equipment, you can increase your viewing options.
b
• Refer to the instructions supplied with the equipment to be connected.
• Before connecting, turn off the player and the equipment to be connected, then unplug from their wall sockets.
z
• When you play back a disc after enjoying
images by “Line In,” press INPUT. See page 7.
• The player can connect to an AV amplifier in the same way as a TV. Although connecting is the same as a TV, the yellow plug of the audio/ video cord is not used.
Enjoying optional connections
1
Connect the player to your video player or camcorder using the audio/video cord (supplied).
INPUT
Enjoying images on a connected TV
1
Connect the player to your TV or monitor using the audio/video cord
(supplied).
POWER OFF ON
HOLD PHONES
A B
INPUT
AUDIO
IN/
OUT
VIDEO
IN/
OUT
DC IN
9.5V
AUDIO
IN/
OUT
VIDEO
IN/
OUT
INPUT
To AUDIO/
VIDEO output jacks of a video player or camcorder
POWER OFF ON HOLD PHONES
A B
INPUT
AUDIO
IN/
OUT
VIDEO
IN/
OUT
DC IN
9.5V
AUDIO
IN/
OUT
VIDEO
IN/
OUT
To AUDIO/
VIDEO input jacks of a TV or monitor
Audio/video cord
(supplied)
2
Press INPUT to select “Line In.”
Audio/video cord
(supplied)
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement