advertisement
SAFETY PRECAUTIONS / MAINTENANCE IMPACT X 440
WARNING: HAZARDOUS VAPORS
Paints, solvents, and other materials can be harmful if inhaled or come in contact with body. Vapors can cause severe nausea, fainting, or poisoning.
PREVENTION:
•
Wear respiratory protection when spraying. Read all instructions supplied with the mask to be sure it will provide the necessary protection.
•
All local regulations regarding protection against hazardous vapors must be observed.
•
Wear protective eyewear.
•
Protective clothing, gloves and possibly skin protection cream are necessary for the protection of the skin. Observe the regulations of the manufacturer concerning coating materials, solvents and cleaning agents in preparation, processing and cleaning units.
2
MAINTENANCE
2.1
PRESSURE RELIEF PROCEDURE
Be sure to follow the Pressure Relief Procedure when shutting down the sprayer for any purpose, including servicing or adjusting any part of the spray system, changing or cleaning spray tips, or preparing for cleanup.
1. Lock the gun by pushing the gun trigger lock to the locked position.
2. Turn off the sprayer by moving the ON/OFF switch to the OFF position.
3. Make sure the pressure control knob is turned fully counterclockwise to its lowest pressure setting.
4. Move the PRIME/SPRAY valve to the PRIME position.
WARNING: GENERAL
This product can cause severe injury or property damage.
PREVENTION:
•
Always wear appropriate gloves, eye protection, clothing and a respirator or mask when painting.
•
Do not operate or spray near children. Keep children away from equipment at all times.
•
Do not overreach or stand on an unstable support. Keep effective footing and balance at all times.
•
Stay alert and watch what you are doing.
•
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•
Do not kink or over-bend the hose. Airless hose can develop leaks from wear, kinking and abuse. A leak can inject material into the skin.
•
Do not expose the hose to temperatures or pressures in excess of those specified by manufacturer.
•
Do not use the hose as a strength member to pull or lift the equipment.
•
Use lowest possible pressure to flush equipment.
•
Follow all appropriate local, state and national codes governing ventilation, fire prevention and operation.
•
The United States Government Safety Standards have been adopted under the Occupational Safety and Health Act (OSHA).
These standards, particularly part 1910 of the General Standards and part 1926 of the Construction Standards should be consulted.
•
Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover. Check for damage or movement of couplings.
Immediately replace hose if any of those conditions exist. Never repair a paint hose. Replace with a conductive high-pressure hose.
•
Do not spray outdoors on windy days.
•
Always unplug cord from outlet before working on equipment
(electric models only).
5. Unlock the gun by pushing the gun trigger lock to the unlocked position.
6. Hold the metal part of the gun firmly to the side of a metal container to ground the gun and avoid a build up of static electricity.
7. Trigger the gun to remove any pressure that may still be in the hose.
8. Lock the gun by pushing the gun trigger lock to the locked position.
6
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement