EME Owners Manual Eco 3 4

Transporting Your Scooter

Warning!

Dismantling the scooter involves lifting and handling heavy parts.

Warning!

Pinching or Crushing. Be careful to avoid being pinched or having your hands crushed when lifting or handling parts. Wear gloves whenever possible. Special attention should be paid when raising and lowering armrests, splitting the front and rear parts of the chassis or rotating/handling the front wheels when dismantling or during re-assembly for transportation in a car or similar.

Warning!

This scooter is not suitable for use as a seat for an occupant in a motor vehicle.

Warning!

Do not leave the scooter standing up on its rear rests when not attended – it could topple and injure somebody.

Warning!

Never stand the scooter up on its rear rests with the battery pack installed.

Warning!

Do not lift the chassis with the batteries still fitted - injury may result!

Your Scooter has been designed to be dismantled and stowed in the average car boot. Contact your dealer for advice on how best to transport your scooter in your vehicle. To transport your Scooter you will need to dismantle it. Follow these instructions. The component weights are recorded in the Technical Specification (p25). Do not attempt to undertake dismantling or lifting without assistance. You are advised to wear gloves.

• Turn the power off. (Turn key to the off position and remove from the scooter).

• Loosen the seat securing thumbwheel. (fig.1)

• Remove the seat by gripping it and pulling up and lifting the seat off the chassis. (fig.2)

• Fold the seat arms down & the seat-back forward on itself for easy storage.

• Remove the battery pack by undoing the battery securing strap and lifting it clear. Warning, these parts are heavy! (fig.3)

• Remove the shopping basket by lifting /sliding up. (fig.4)

• Loosen the tiller thumbwheel, fold the tiller unit down and re-tighten the thumbwheel. (fig.5)

2

4

1

3 5

15