Parking Brake Adjustments. Scag Power Equipment STHM, STHM Three-Wheel Rider
Add to My manuals
66 Pages
advertisement
ADJUSTMENTS
PARKING BRAKE
Minor brake adjustments can be made by loosening the top nut on both brake cables (see Figure 4).
Back the nuts off approximately 1/4". While pulling one cable downward, tighten the bottom nut on the cable until it touches the bottom of the brake cable mount. Tighten both the top and bottom nuts to lock the cable in place. Repeat the above steps for the second brake cable. Make sure that both cables are adjusted evenly so that the brakes do not cause the mower to pull to the left or right.
-NOTE-
This is a minor brake adjustment. If the brakes do not function properly after this adjustment, see your Scag Service Dealer before operating your mower.
If the drive wheels consistently rotate when foot pedal control is in neutral, go to step 4.
If the drive wheels inconsistently rotate, i.e. drive wheels sometimes rotate and sometimes do not when foot pedal is not depressed, then check neutral adjustment bolt for "zero free play" in neutral control spring.
-NOTE-
If there is free play in the foot pedal have your
SCAG servicing dealer inspect the machine and repair it as needed.
4. If the drive wheels rotate in the forward travel direction, turn the adjustment bolt clockwise until the tire rotation stops. If the drive wheels rotate in the backward travel direction, turn the adjustment bolt counter-clockwise until the tire rotation stops (See
Figure 5).
Adjust
Nuts
SGB028
Figure 4. Parking Brake Adjustment
NEUTRAL ADJUSTMENT
1. Set the engine deck up on jack stands so the wheels are free to rotate.
2. Block the caster wheels to prevent an accident should the machine fall off the jack stands.
3. Start the engine and determine if the drive wheels rotate.
8
Neutral Control
Spring
9/16" Socket
Figure 5. Neutral Adjustment
SGB029
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 General Safety Instructions
- 5 Signal Words
- 6 Symbols
- 8 Before Operating
- 8 While Operating
- 9 Maintenance and Storage
- 10 Initial Run-In Procedures
- 10 Mower Operation
- 12 Parking Brake Adjustments
- 12 Neutral Adjustment
- 13 Belt Tension
- 14 Belt Alignment
- 14 Cutter Deck Adjustments
- 15 Cutter Blades
- 15 Custom-Cut Baffle Adjustment
- 17 Lubrication and Maintenance
- 18 Troubleshooting Cutting Conditions
- 21 Technical Specifications
- 23 Notes