advertisement
I
NORME DI SICUREZZA – IMPORTANTE
Questa apparecchiatura è stata costruita in accordo alle norme di sicurezza IEC 65. Per una perfetta sicurezza ed al fine di evitare eventuali rischi di scossa êlettrica o d'incendio vanno osservate le seguenti misure di sicurezza: o o o o
Assicurarsi che il selettore di cambio tensione sia posizionato sul valore corretto.
Assicurarsi che la portata ed il tipo di fusibili siano quelli prescritti dalla casa costruttrice.
L'apparecchiatura deve avere un collegamento di messa a terra ben eseguito; anche la connessione rete deve avere un collegamento a terra.
Il cavo di alimentazione a corredo dell'apparecchiatura deve essere collegato come segue:
Filo tensione Marrone
Neutro Blu
Massa Verde/Giallo enhance. The selected signals then pass on to the summing stage where they are added to the original untreated signal.
The EQUALIZATION section is similar to a three-way loudspeaker crossover network. Low, Mid and High controls set the amount of boost in their respective bands while two crossover controls set the crossover frequencies between the Low, Mid, and High bands.
Source Noise Reduction
The Spectral Processor boosts low-level signals while leaving highlevel signals relatively unchanged. It can be thought of as an “audio magnifying glass” which “magnifies” detail in selectable areas of the spectrum.
A side effect of this “magnification” is that some of the details that are magnified may be undesirable -- the most common unwanted detail which may be revealed is noise.
For this reason each channel contains a “source-noise reduction” or
“SOURCE NR” section. This SOURCE NR section uses a sliding-band technique that can reduce noise present in the input signal by up to 12 dB. Selectable high-frequency and low-frequency side-chain filters are also provided to prevent unwanted signals from entering the low level processing stage.
30
METER
THRESHOLD
8 BAND
PROCESSOR
EQ
HIGH
MID
LOW
+
SOURCE-NOISE
REDUCTION
+
IN
SIDECHAIN
OUT
INPUT
Audio Path
Control Path
SPECTRAL PROCESSOR BLOCK DIAGRAM (ONE CHANNEL)
OUTPUT
MAIN
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Low-level Processing - a new idea
- 6 The Gain Elements
- 6 Combining Fixed and Sliding Bands
- 6 Multi-level Processing
- 6 Three-band EQUALIZATION Control
- 7 Source Noise Reduction
- 9 Specifications
- 13 Installation
- 14 Power Connections
- 15 Audio Connections
- 15 For Balanced Systems
- 15 For Unbalanced Systems
- 16 Operating level
- 17 Controls
- 17 Threshold Section
- 18 Equalization Section
- 18 Crossover Control
- 19 Equalization Mode Switch
- 19 Source NR Section
- 19 Filter Switches
- 20 Output Level Control
- 21 Stereo Link Switch
- 21 Power LED
- 23 Some General Techniques
- 24 “Extending” the frequency response
- 25 Emphasizing Mid-Range Frequencies
- 26 Bringing Out Ambience
- 27 Using the Source NR Section
- 28 Using the Side Chain Output
- 30 Safety Notices
- 37 Sheets for recording control settings