Menvier TS790 & TS900

User Menu 3 TS790 & TS900 User Manual

Code Set Groups - [3.3]

This option allows the user passcode types “Code Set Group A”, “Code Set Group B”, “Code Set

Group C” and “Full Set Group” to be defined so that each may Set or Unset any combination of

Wards (A, B and C) and the System Ward. e.g., “Code Set Group A” may be defined to Set and

Unset Wards A and B only and “Code Set Group B” defined to Set and Unset Wards B, C and the system etc.

LCD Starburst

LED

1. Ensure that “User menu 3" is selected.

Press 3 to select the Code Set Groups option. The display will show:

Code set Group ?

Enter Group >-

C.S GRP-

CSG.-

2. Select the Code set group by pressing:

A To select “Code set Group A”

B To select “Code set Group B”

C To select “Code set Group C”

0 To select “Full set Group” e.g., To select “Code set Group A”, press “A”. The display will show:

3. Select/de-select the wards by pressing:

Code set Group A

Will set [ A ]

A

A

0 To select/de-select “Ward S”

A To select/de-select “Ward A”

B To select/de-select “Ward B”

C To select/de-select “Ward C” e.g., to add “Ward C”, press “C”. The display will show:

4. When the display shows the required setting press [ to accept. The display will return to step 1, repeat for the other “Code set Groups” or press ] to return to “User menu 3".

Code set Group A

Will set [ A C]

A C

A C

Code Set Group Operation

When the system is unset and a “Code set Group” passcode is entered the selected areas

(wards) will set after the setting procedure is followed. e.g., If “Code set Group A” is defined as above then when the passcode is entered it will set wards A and C. If the system is fully set and the passcode is entered it will unset wards A and C.

The “Code set Group” passcodes are programmed by the master user within “User menu 2" (see

page 25).

40