Vehicle Power Management Setup

Chapter 3: System Setup

Chapter 3: System Setup

Installing a WLAN module or WWAN module

Prior to removing the chassis cover, make sure the unit’s power is off and disconnected from the power sources to prevent electric shock or system damage.

1. Remove these screws and put them in a safe place for later use.

2. Remove the rear cover of the VMC1000.

The Mini PCI Express slot shown below is used to install a WLAN module or 3.5G commu-nication module such as GPRS,

UMTS or HSDPA module.

For 3.5G module

For WLAN module mSATA

VMC 1000 User Manual Copyright © 2011 NEXCOM International Co., Ltd. All rights reserved

29

Chapter 3: System Setup

System Setup

3. Insert the module into the Mini PCI Express slot at a 45 degrees angle until the gold-plated connector on the edge of the module completely disappears inside the slot. And then attach RF cable to the module.

4. Before you install the rear cover, please check the all thermal pads are on the heatsink.

Copyright © 2011 NEXCOM International Co., Ltd. All rights reserved

30

VMC 1000 User Manual