Safe & SoundTM audio monitor Online user`s manual

Getting started

Parent unit battery charging

The parent unit turns on after you have installed the parent unit battery or connected the parent unit to AC power (see pages 3 to 5). The battery icon indicates the battery status (see the table b elow). The parent unit batte ry is fully charged after 11 hours of continuous charging. See the table on page 19 for battery operating time.

When the parent unit is operating in battery mode and the battery is low, you need to charge the parent unit without interruption for at least 30 minutes to give the parent unit enough charge to use for a short time. When operating in low battery condition, LOW BATTERY and flash on the parent unit. The

light flashes and the parent unit plays short beeps to alert you.

The following table summarizes the battery charge indicators and actions to take.

Battery indicators Battery status

The battery icon is off.

No battery is installed. The parent unit can be used only when it is connected to AC power.

LOW BATTERY

and

flash on the screen.

The light flashes.

The battery icon becomes solid .

The battery has very little charge and may be for only a short time.

used

Action

Install the parent unit battery.

Charge without interruption

(at least 30 minutes).

Charge without interruption

(about 30 minutes).

The battery is fully charged. To keep the battery charged, connect it to AC power when not in use.

When you charge the battery pack initially or it is not used for a long period of time, charge it for 11 hours continuously. It takes longer to charge the battery when the parent unit is turned on. To shorten the charging time, turn the parent unit off.

6