Installation & User Manual

EM1005X- Installation/User Manual

Ordering the System

The i8305 is configured using DIP switches for determining the EIM location; Port or Starboard and configuring the tachometer pulses per revolution (PPR) to match the engine flywheel teeth count. Another parameter stored is the engine hours. Should the EM1005x be ordered without the M701x Display, this data must be defined when placing the order.

See Table Below:

ENGINE POSITION: Port or Starboard

ENGINE HOURS:

SENDER 2 INPUT:

FLYWHEEL COUNT: xxx.x Hours

Defaults:

Fuel Tank 3 for Port

Fuel Tank 4 for Starboard

(Can be configured via

M701x for Water, Waste,

Rudder Angle or “Not Used”.)

129, 127, 117, 116 or 97

LY2 129

LP 117

JH4 116

JH4T 127

YM 97

Note 1. A charge alarm will activate the EM1005x alarm output but may not be present on the TFX i5601 display.

Note 2. Boost Alarm (over boost) is not available.

Copyright 2010 MBW Technologies, LLC All Rights Reserved 7

EM1005X- Installation/User Manual

Reading the configuration settings of the i8305 requires removing the top cover and noting the DIP switch settings. See Table below.

Switch

5

Switch

4

Switch

3

Switch

1

PPR

97

PPR 114

Off

Off

Off

Off

Off

On

X

X

PPR 116

PPR 117

PPR 127

PPR 129

PORT

STBD

Off

Off

On

On

On

On

Off

Off

Off

On

Off

On

X

X

X

X

Off

On

8 7 6 5 4 3 2 1

ON

8 7 6 5 4 3 2 1

ON

i8305 Dip Switch Locations and Settings

8 Copyright 2010 MBW Technologies, LLC All Rights Reserved