9.17 Message center. Xenun XT-009

XT-009 Gps tracker user manual

9.17 SMS Center

z

Setup: Send SMS adminsms+password+space+cell phone number to setup the SMS center.

The tracker will reply Geo-info & authorized number to sms center number even if the admin numbers call or sending command to the tracker z

Cancel: Send SMS noadminsms+password to cancel the SMS center.

Note:

z

The SMS message must be Text format, can’t be identified for PDU format.

z

Please use the tracker outside for the first time in order to it can get gps signal easily and quickly

9.18 GSM ID

GSM ID is in each sms or gprs data. The tracker can be found by GSM ID without gps signal. But the customers have to ask their GSM operator for data base of the GSM ID.

9.19 Motion (Acceseleration)Sensor

z

Setup: Send SMS shake+password+space+1-10 to the tracker to set up this function

(1-10 means the level of intensity) z

Send SMS shake+password+space+1 is the least sensitivity . Have to shake the tracker strongly to get the alert.

z

Send SMS shake+password+space+10 is the most sensitivity . Have to shake the tracker slightly to get the alert z

Cancel: Send SMS shake+password+space+0 to remove this function.

9.20 Micro SD card

Put Micro sd card to the tracker SD card slot. The GPRS data can be saved in the SD card if there is no gsm/gprs network. It will send data to the GPRS server again after connection gsm/gprs network.

z

Setup: Send SMS sdlog+password+space+1 to activate the sd card-saving function z

Setup: Send SMS readsd+password+space+1 to ask the tracker to send data in the SD card to the GPRS server.

z

Cancel: Send SMS sdlog+password+space+0 to the tracker to deactivate this function z

Cancel: Send SMS readsd+password+space+0 to ask the tracker to stop sending data in the SD card to the server.

Remark: only need to configure one time before using this function.

13