Assembly. JET J-2550, J-2530, J-2500

Assembly

Read and understand all assembly instructions before attempting assembly! Failure to comply may cause serious injury!

Before Assembly

1. Remove the contents from the shipping container.

2. Compare the contents of the shipping container with the list found above. Report any shortages or damage to your JET distributor.

3. Clean all rust protected surfaces with kerosene or a light solvent. Do not use lacquer thinner, paint thinner, or gasoline. These will damage plastic components and painted surfaces.

Column Assembly

Referring to Figure 1: the and align the holes in the column support with the holes in the base.

3. Note: The column shown in Figure 1 is for the

JDP-15MF. While the JDP-15M column is slightly different in appearance, the assembly procedure is the same.

4. Using a 17mm wrench, secure the column (B) with four M10 x 40 hex cap screws (C) to the base.

2. Install the table bracket (A) together with the rack (B) as shown in Figure 2.

Figure 2

3. Slide the rack ring (D) over the column (C), placing it so it rests against the rack (B) as shown in Figure 3 and tighten firmly.

Figure 3

Crank Handle and Table Lock Handle

Referring to Figure 4 (shown already assembled):

1. Loosen the setscrew (B) on the table crank

handle (A).

3. Turn the handle until the setscrew is opposite the flat section on the shaft, and tighten the setscrew to secure the handle.

Figure 1

Table Bracket

When shipped, the rack ring and rack are bundled together with the column in plastic wrap.

Referring to Figures 2 and 3:

1. Remove the wrap and take the rack ring (D) and

rack (B) off the column (C).

8

Figure 4