QuickSpecs HP EliteDesk 705 G1 Desktop Mini Business PC Overview

QuickSpecs

Technical Specifications – Memory

HP EliteDesk 705 G1 Series Business Desktop

System Memory Support

The HP EliteDesk 705 G1 Business PC supports DDR3/DDR3L protocols with two independent, 64-bit wide channels each accessing one or two DIMMs.

Two channels of non-ECC DDR3/DDR3L unbuffered dual in-line memory modules (UDIMM) or DDR3/DDR3L unbuffered small outline dual in-line memory modules (SO-DIMM) with a maximum of two DIMMs per channel

Single-channel and dual-channel memory organization modes

Data burst length of eight for all memory organization modes

Memory data transfer rates of up to 1600 MT/s; actual supported data transfer rate determined by the configured processor.

64-bit wide channels

DDR3/DDR3L system memory I/O voltage of 1.5V

Theoretical maximum memory bandwidth of:

21.3 GB/s in dual-channel mode assuming 1333 MT/s

25.6 GB/s in dual-channel mode assuming 1600 MT/s

25.6 GB/s in dual-channel mode assuming 1600 MT/s

Platform Memory Support

The Small Form Factor (SFF) and Microtower (MT) platforms support up to four (4) industry-standard DDR3-SDRAM

DIMMs.

The Desktop Mini (DM) supports up to two (2) industry-standard DDR3-SDRAM SO-DIMMs.

CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules.

Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged in to an active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system board.

NOTE: For systems configured with more than 3 GB of memory and a 32-bit operating system, all memory may not be available due to system resource requirements. Addressing memory above 4 GB requires a 64-bit operating system.

DA - 15002 Worldwide QuickSpecs — Version 12 — 12.1.2014

Page 40