Windscreen. TRIUMPH 2010 Rocket III

General Information

Caution

To prevent damage to the seat or seat cover, care must be taken not to drop the seat. Do not lean the seat against the motorcycle or any surface which may damage the seat or seat cover. Instead, place the seat, with the seat cover facing upwards, on a clean, flat surface which is covered with a soft cloth.

Do not place any item on the seat which may cause damage or staining to the seat cover.

To refit the seat, engage the seat’s tongue under the fuel tank, fit and tighten the side fixings to 15 Nm.

Fit the rear fixing, with the reflector, and tighten to 9 Nm.

Windscreen

Note:

• The windscreen fitted to this motorcycle can be removed without the use of tools.

To remove the windscreen

2

5

1

3

Warning

To prevent detachment of the seat during riding, after fitting always grasp the seat and pull firmly upwards. A loose or detached seat could cause loss of motorcycle control and an accident.

4

cenp

1. Upper mounting

2. Lock handle

3. Lock

4. Lower mounting

5. Windscreen

To remove the windscreen, stand astride the front wheel. Pull the lock handles towards the windscreen to release the locks from the upper mountings. For complete removal from the motorcycle, lift the windscreen up until it is released from the upper and lower mountings.

33