User Guide - Remote Control Kit

ZPM-RT

Remote Control Kit for Spectrum2 Series

What’s included

:

G. AAA Batteries

110”

A. B.

Red+ Green -

IR Remote RF Remote C. 12V Trigger D. IR ey receiver

F. Wall box

ZPM-RT Installation & Control Instructions1

1. Disconnect the 3 Way Control Switch from the Spectrum2 as shown below.

3 Way Control Switch

Screen

Rev1204-12-JA www.elitescreens.com

1

2. Connect the Wall Box (F) to the screen as shown below.

Wall box (F) Screen

ZPM-RT Installation & Control Instructions 2

Please consult a professonial installer for this procedure. Elite Screens is not responsible for faulty installations.

1. Cut the cable of both the Wall Box (H) and the attached Control Switch to expose the wires.

Cut Cable

Cut Cable

Wall Box (H)

2. Connect the wires from the screen to the Wall box (H) according to their specific color.

Purple Wire = Up

Orange Wire = Down

Yellow Wire = Common

Yellow & Green Wire = Ground

Purple Wire = Up

Orange Wire = Down

Yellow Wire = Common

Yellow & Green Wire = Ground

Rev1204-12-JA www.elitescreens.com

2

3. The Wall Box (H) should be connected to your screen as shown below.

Wall Box (G)

12 Volt Trigger (E)

1. Connect the 12 Volt Trigger (C) to the Wall Box (H) for set up to your projector.

Wall Box (G)

12 Volt Trigger (E)

Red Wire +

DC12V

Green Wire -

0V Connect to Projector

IR Eye Receiver (D)

1. Connect the IR Eye Receiver (D) to the Wall Box (H) for high wall or ceiling installations

Wall Box (H)

IR Remote (A)

IR Eye Receiver (D)

For a local Elite Screens contact or Technical Support, please visit www.elitescreens.com

Rev1204-12-JA www.elitescreens.com

3