Hair Clipper

Hair Clipper

2.

Seite 2 mm kürzer

6.

4.

3.

1.

5.

Model No. HC365

08/UK/HC365 Version 02/08 Part No. T22-25969

Remington

®

Registered Trade Mark of spectrum Brands, Inc., or one of its subsidiaries

VARTA Consumer Batteries GmbH & Co. KGaA

Alfred-Krupp-Str. 9

73479 Ellwangen

Germany www.remington-products.com

© 2008 SBI

080162_REM_IFU_HC365_UK.indd 1-3

HC365

HC365

28.02.2008 13:59:54

Seite 2 mm kürzer

Seite 2 mm kürzer

1.

4.

2.

5.

6

3.

REMINGTON

®

SERVICE HOTLINES

United Kingdom

+44 0800 212 438 (free call)

Rayovac Europe Ltd,

Watermans House, Kingsbury Crescent,

The Causeway, Staines, Middlesex,

TW18 3BA, UNITED KINGDOM www.remington.co.uk

080162_REM_IFU_HC365_UK.indd 4-6

Seite 2 mm kürzer

28.02.2008 13:59:56

ENGLISH

Thank you for choosing Remington

®

. Our products are designed to meet the highest standard of quality, functionality and design. We hope you enjoy using your new Remington ® product.

Please read the instructions for use carefully and keep in a safe place for future reference.

CAUTION

Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Remington ® .

Do not use this product if it is not working correctly, if it has been dropped or damaged, or dropped into water.

DESCRIPTION

1. On/Off s witch

2. Blade s et

3. Taper l ever

4. 8 attachment guide combs

5. Charge indicator light

6. Charging a daptor

080162_REM_IFU_HC365_UK.indd 1

1

28.02.2008 14:00:36

ENGLISH

GETTING STARTED

CHARGING YOUR HAIRCLIPPER

Before using your hair clipper for the fi rst time, charge for 14-16 hours.

Ensure the product is switched off.

Connect the charging adaptor to the product and then to the mains.

The charging indicator will light up.

Your clipper cannot be overcharged. However, if the product is not going to be used for an extended period time (2-3 months), unplug it from the mains and store.

Fully recharge your hairclipper when you would like to use it again.

To preserve the life of your batteries, let them run out every six months then recharge for

14-16 hours.

CORDED U SE

Connect the charging adaptor to the product and then to the mains.

CAUTION: Extended mains only use will result in the reduction of the battery life.

HOW TO USE

Before starting the cut

Inspect the clipper making sure that it is free from hair and dirt.

Seat the person so that their head is approximately at your eye level.

Before cutting, always comb the hair so it is tangle free and dry.

To attach a comb

Hold the comb with its teeth upward

Slide it onto and along the clipper blade until the front of the comb fi rmly sits against the clipper blade.

To remove the comb

Holding the clipper with the blades facing away from you, fi rmly push the comb upward and away from the blades.

2

080162_REM_IFU_HC365_UK.indd 2 28.02.2008 14:00:36

Each comb attachment is marked accordingly on its outside middle surface. (3mm, 7mm,

9mm, 12mm, 18mm, 25mm, left and right ear guide)

Replacement combs available. Model: SP254

INSTRUCTIONS FOR HAIR CUTTING

Note: For even cutting, allow the comb attachment/blade to cut its way through the hair.

Do not force it through quickly. If you are cutting for the fi rst time, start with the maximum comb attachment.

STEP 1 – Nape of the neck – PICTURE 1

Use 3mm or 7mm guide comb.

Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the head at the base of the neck.

Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time.

STEP 2 – Back of the head – PICTURE 2

With the 12mm or 18mm guide comb attached, cut the hair at the back of the head.

STEP 3 – Side of the head – PICTURE 3

With the 3mm guide comb attached, trim sideburns. Then change to the longer 9mm guide comb and continue to cut to the top of the head.

STEP 4 – Top of the head – PICTURE 4

With the 18mm or 25mm guide comb attached, cut hair on top of the head against the direction in which the hair normally grows.

For longer hair on top, use without a guide comb. Lift the hair on top of the head with a small hand comb. Cut over the hand comb with the hair lifted or hold the hair between the fi ngers to lift it and cut it to the desired length.

Always work from the back of the head.

080162_REM_IFU_HC365_UK.indd 3

3

28.02.2008 14:00:36

ENGLISH

STEP 5 – The fi nishing touches – PICTURE 5

Use the clipper without an attachment comb for close trimming around the base and sides of the neck. Use the ear comb guides to get a clean line around each ear. For the required ear comb guide, angle the clipper and lightly stroke around each ear to the back of the neck.

To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at right angles to the head, tips of the blades lightly touching the skin and then work downwards.

SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS

Starting with the longest guide comb attached (25mm), cut from the back of the neck to the crown. Hold the guide comb fl at against the head and slowly move the clipper through the hair, as shown. (PICTURE 1)

Use the same procedure from the lower side to the upper side of the head, as illustrated.

Then cut the hair against the direction in which it grows and level with the sides.

(PICTURE 3)

To give a “fl at top” look, the hair on top of the head must be cut over the top of a fl at comb.

Use a closer guide comb to taper the hair down to the neckline as desired.

TAPER L EVER

This product has a taper lever located a the left side of the clipper near the blades. Adjust the lever to change the closeness of the cut gradually and also to improve the effectiveness of the comb attachments. The taper lever also extends the life of the blades because a different cutting edge is used in each setting.

CARE FOR YOUR HAIRCLIPPER

Your clipper is fi tted with high quality ceramic blades that are premanently lubricated. To ensure long lasting performance of your clipper, clean the blades and unit regularly. Always keep the protective cap on the trimmer blade.

AFTER EACH USE

Ensure the clipper is switched off and disconnected from the mains.

Brush the accumulated hair from the blades. Do not submerge the clipper in water.

To clean the unit, wipe with a damp cloth and dry immediately.

Note: Ensure that the clipper is turned off when cleaning.

EVERY SIX MONTHS

At regular intervals the Blade Set should be removed and cleaned.

Remove the 2 screws retaining the fi xed blade with a screwdriver.

Do not remove blade set.

4

080162_REM_IFU_HC365_UK.indd 4 28.02.2008 14:00:37

Brush out hairs from between the blades with soft cleaning brush. Do not remove the lubricating grease from the blades. It is not necessary to remove the small moving blade from the unit.

If the moving blade has been removed this can be re-fi tted by slotting the long grooved edge of the blade onto the two white plastic guide ridges and then seating the blade over the plastic actuator bar. The fi xed blade is fi tted with the raised profi le pointing outwards and fi xed with the 2 screws.

Before fully tightening the 2 screws, adjust the taper lever to the lower position and align the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.

Note that if the blades are not correctly aligned then cutting effi ciency will be impaired.

Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.

CAUTION: Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the blade casing. Always use a soft brush to remove the accumulated hairs.

Unplug the charge adaptor from the power outlet when fi tting or removing attachments, or while cleaning the product.

Always store this appliance and cord in a moisture-free area.

Do not wrap the cord of the charging adaptor around the appliance.

TROUBLESHOOTING

If blades do not seem to cut hair easily, the taper lever (PICTURE 6) can be used to remove any hair caught between the comb and blade. Switch the clipper on and move the taper lever up and down a few times but do not force the lever in either direction. This should remove hairs and restore the cutting effi ciency. If not, contact your nearest Remington Service

Centre.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR

INJURY TO PERSONS:

An appliance should never be left unattended when plugged into a power outlet.

Keep the power plug and cord away from heated surfaces.

Make sure the power plug and cord do not get wet.

Do not plug or unplug the shaver with wet hands.

Do not use the product with a damaged cord. A replacement can be obtained via our

Remington

®

service center.

Charge, use and store the product at a temperature between 15°C and 35°C.

Always unplug from the mains when cleaning.

Only use the parts supplied with the appliance.

Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give explicit instructions or supervise the use of the appliance.

5

080162_REM_IFU_HC365_UK.indd 5 28.02.2008 14:00:37

ENGLISH

PROTECT THE ENVIRONMENT

The product contains a Nickel Metal Hydride cell unit. Do not dispose the trimmer in household waste at the end of its useful life. Disposal can take place at our service centres or appropriate collection sites.

CAUTION: Do not put in fi re or mutilate your battery packs as they may burst or release toxic materials.

For further information on recycling see www.remington-europe.com

WARRANTY

This product has been checked and is free of defects. We warrant this product against any defects that are due to faulty material or workmanship for the warranty period from the original date of consumer purchase. If the product should become defective within the warranty period, we will repair any such defect or elect to replace the product or any part of it without charge provided there is proof of purchase. This does not mean an extension of the warranty period.

In the case of a warranty simply call the Remington ® Service Center in your region.

This warranty is offered over and above your normal statutory rights.

The warranty shall apply in all countries in which our product was sold via an authorised dealer.

This warranty does not include damage to the product by accident or misuse, abuse, alteration to the product or use inconsistent with the technical and/or safety instructions required. This warranty shall not apply if the product has been dismantled or repaired by a person not authorised by us.

6

080162_REM_IFU_HC365_UK.indd 6 28.02.2008 14:00:38

080162_REM_IFU_HC365_UK.indd 7 28.02.2008 14:00:35

080162_REM_IFU_HC365_UK.indd 7

7

28.02.2008 14:00:38