Toyota Speed Sensor Manual

BRAKE CONTROL – FRONT SPEED SENSOR
BC–197
INSPECTION
1.
INSPECT FRONT SPEED SENSOR
(a) Check the speed sensor.
If any of the following occurs, replace the speed
sensor with a new one.
• The surface of the speed sensor is cracked,
dented or chipped off.
• The connector is scratched, cracked or
damaged.
• The speed sensor has been dropped.
INSTALLATION
C133068
1.
INSTALL FRONT SPEED SENSOR
(a) Using a 5 mm hexagon wrench, install the front
speed sensor with the bolt.
Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
NOTICE:
Make sure that the sensor tip is clean.
(b) Connect the skid control sensor wire.
2.
INSTALL FRONT WHEEL
Torque: 112 N*m (1,137 kgf*cm, 82 ft.*lbf)
3.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
4.
CHECK VSC SENSOR SIGNAL
(See page BC-28)
BC
">