![](http://s1.manualzz.com/store/data/011348761_1-b56c27243f759c8a344dbdc6dd9770bf-128x128.png)
HX421C13SBK2/16 Memory Module Specifications SPECIFICATIONS 16GB (8GB 1G x 64-Bit x 2 pcs.)
Add to My manuals2 Pages
advertisement
![HX421C13SBK2/16 Memory Module Specifications SPECIFICATIONS 16GB (8GB 1G x 64-Bit x 2 pcs.) | Manualzz HX421C13SBK2/16 Memory Module Specifications SPECIFICATIONS 16GB (8GB 1G x 64-Bit x 2 pcs.) | Manualzz](http://s1.manualzz.com/store/data/011348761_1-b56c27243f759c8a344dbdc6dd9770bf-360x466.png)
Memory Module Specifications
DDR4-2133 CL13 288-Pin DIMM Kit
DESCRIPTION
HyperX HX421C13SBK2/16 is a kit of two 1G x 64-bit (8GB)
DDR4-2133 CL13 SDRAM (Synchronous DRAM) 2Rx8, memory modules, based on sixteen 512M x 8-bit FBGA components per module. Total kit capacity is 16GB. Each module supports
Intel® XMP (Extreme Memory Profiles). Each module has been tested to run at DDR4-2133 at a low latency timing of
13-13-13 at 1.2V. The SPDs are programmed to JEDEC standard latency DDR4-2133 timing of 15-15-15 at 1.2V.
Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows:
XMP TIMING PARAMETERS
•
JEDEC: DDR4-2133 CL15-15-15 @1.2V
•
XMP Profile #1: DDR4-2133 CL13-13-13 @1.2V
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
15 cycles
46.5ns (min.)
260ns (min.)
33ns (min.)
TBD W*
94 V - 0
0 o C to +85 o C
-55 o
C to +100 o
C
*Power will vary depending on the SDRAM used.
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.36” (34.57mm) hyperxgaming.com
Continued >>
Document No. 4807400-001.A00 08/27/15 Page 1
continued
MODULE WITH HEAT SPREADER
MODULE DIMENSIONS
133.35
129.55
2.10± 0.15
3.00
Pin 1
3.35
Detail A
28.90
Detail B
Pin 35 Pin 47
64.60
Detail D Detail E Detail C
Pin 105 Pin 117
56.10
22.95
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
HyperX is a division of Kingston.
©2015 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4807400-001.A00 Page 2 hyperxgaming.com
advertisement
Related manuals
advertisement