PreSonus StudioLive 16.4.2 16x4x2 Performance and Recording Digital Mixer Installation Instructions

StudioLive Rack Ear Installation Instructions

Step 1:

Using a Philips screwdriver, remove the three screws beneath the decorative plastic side panel on the right side of your StudioLive. Set these screws aside.

You will need them should you want to reinstall the side panel at some point in the future.

Step 2:

Gently slide the plastic side panel toward the front of your StudioLive until you hear a click. Pull the side panel toward you to remove it.

Step 3:

Once the side panel is removed, you will see three metal clips. Remove the screw that attaches each of these clips to your StudioLive. Set aside these screws. You will need them to attach the rack ear to your StudioLive.

It is recommended that you attach the clips back to the decorative side panel using the screws you removed in Step 1 to store them. Both the clips and screws are necessary to reattach the side panel.

Step 4:

Remove the four screws at the top. These 5mm screws will be replaced with slightly longer ones. Set them aside and store them with the side panel.

Step 5:

Using the screws you removed from the metal clips in Step 3, attach the Rack

Ear labeled ‘R’ to your StudioLive. In your Rack Ear installation kit, you will find four 6mm screws. Thread these through the four holes at the top of the Right Rack

Ear and attach them to your

StudioLive.

Repeat these steps to attach the Left Rack Ear to your StudioLive.