Bunn-O-Matic FMD-4 Specification sheets
Add to my manuals
2 Pages
Bunn-O-Matic FMD-4 is a versatile and powerful fresh mix dispenser designed to meet the demands of commercial foodservice operations. With its four hoppers, each holding either 8 or 4 pounds of product, the FMD-4 can dispense a wide variety of beverages, including hot chocolate, cappuccino, and iced tea. The large, lighted front graphics make it easy to identify the different products, and the variable speed motors allow for precise control of the product consistency.
advertisement
Item#
Fresh Mix Dispenser with 4 or 5 Hoppers
Project
Date
Features
Fresh Mix Dispensers with 4 or 5 Hoppers
• capacity: FmD-4: one 8-pound hopper; three, 4-pound hoppers
FmD-5: Five, 4-pound hoppers
• Large, lighted front graphics for merchandising.
• 6.4 gallon (24.2 litres) hot water tank to meet peak serving times.
• cup clearance at 7” (17.8 cm) to accommodate common cup sizes.
• electrical and plumbing components easily accessible through front and top.
• Variable speed motors allow control of product consistency in mixing
chamber (.75 to 6.6 grams of powder per second).
• High speed, heavy-duty whipper for complete product mixing.
• Front of machine access to tank drain for easy service.
• Key lock on the door prevents tampering.
FMD-4
Dimensions: 29.3”H x 18.6”W x 21.2”D
(74.4 cm H x 47.2 cm W x 53.8 cm D)
FMD-5
Dimensions: 29.3”H x 18.6”W x 21.2”D
(74.4 cm H x 47.2 cm W x 53.8 cm D)
For current specification sheets and other information, go to www.bunn.com.
Related Products
Easy Clear ® EQHP-10
Product No. : 39000.0004
Easy Clear ® EQHP-10L
Product No. : 39000.0001
Features deluxe whipper chambers:
1. robust whipper to ensure full flavor yield.
2. Specially designed self cleaning mixing chamber.
3. exhaust fan to siphon off moisture that can cause powder buildup.
4. Hot water dispense for easy clean-out.
5. Quick disconnecting parts for thorough sanitizing.
RE
LE
AS
TO
N W
HE
N C
UP
IS
2/3
PL
AC
CU P H
ER
E
Single hopper model shown.
Whipper Chamber
Receptacle
O-ring
Steam Collector
Mixing Chamber
Frother
Whipper
Chamber
Model
FmD-5
FmD-4
Agency Listing
7/10 D4.1
Dimensions & Specifications
Model Product # Volts Amps Tank Heater Total Capacity
Watts Watts
Cubic Shipping
Measure Weight
Cord
Attached
FmD-4
FmD-5
34900.0002
34900.0000
120
120
15
15
1700
1700
1800 4.2 gal/hr** 11 ft
1800 4.2 gal/hr** 11 ft
3
3
118 lbs.
123 lbs.
*Power cord (NEMA 5-15P) 15 Amp-120V machine only. **Based on incoming water temperature of 50 o F/10˚C.
Yes*
Yes* electrical: 120V model requires 2-wires plus ground service rated 120V, single phase, 60 hz. 120/240V model requires
3-wires plus ground service rated 120/208 or 120/240V, single phase, 60Hz.
Plumbing: 20-100 psi (138-690 kPa) from a 3⁄8” or larger supply line. a shut-off valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied with 3⁄8” male flare fitting.
FRONT VIEW
19.30
19.30
1.50
FMD-4
SIDE VIEW
21.15
FMD-5
BACK VIEW
18.60
17.68
18.50
29.26
25.26
4.00
14.66
15.68
Bunn-o-matic ® corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
BUNN ® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
all dimensions shown in inches. 7/10 © 2010 Bunn-O-Matic Corporation
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement