DISH Network ViP 222k satellite receiver User Guide

Remote Controls
Improving Receiver Control
6 Press SELECT on the receiver’s front panel to close the System Information screen.
Checking the Remote Control Address
1 Press and hold the SAT mode button until all of the mode buttons light up, then release it.
2 Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (for example, three flashes means address 3).
Confirming Remote Control Operation
1 Make sure the remote contains fresh batteries and is in SAT mode (to verify, press the
SAT Mode button).
2 Press SYSTEM INFO on the receiver front panel to display the System Information screen
on the nearby TV.
3 Press RECORD on the remote control:
•
Remote Control 1—The Primary Remote Address in the System Information screen
changes to match the address preset in your TV1 remote control. Typically, the remote
control for the nearby TV is IR only, unless you have received an IR/UHF Pro remote
replacement.
•
Remote Control 2—The Secondary Remote Address in the System Information
screen changes to match the address preset in your TV2 remote control. Oddnumbered TV2 remote addresses automatically use UHF Pro Band A, while evennumbered addresses use UHF Pro Band B. If you have two UHF Pro remotes in your
house, ensure one uses an odd-numbered address and the other an even-numbered
address. If you have more than two DISH Network remotes, then consult the SYSTEM
INFO screen on each DISH Network receiver and ensure that all the IR/UHF Pro
remotes use different addresses.
4 Select Done to close the System Information screen.
57
">