Red Hat Global File System 5.2 File System Software Administrator's Guide

Mounting a File System
Flag
Parameter
-t
LockTableName
Description
Used in a clustered file system. This parameter has
two parts separated by a colon (no spaces) as
follows: ClusterName:FSName.
ClusterName is the name of the Red Hat cluster for
which the GFS file system is being created. The
cluster name is set in the
/etc/cluster/cluster.conf file via the Cluster
Configuration Tool and displayed at the Cluster
Status Tool in the Red Hat Cluster Suite cluster
management GUI.
FSName, the file system name, can be 1 to 16
characters in length, and the name must be unique
among all file systems in the cluster.
-V
Displays command version information.
Table 3.1. Command Options: gfs_mkfs
2. Mounting a File System
Before you can mount a GFS file system, the file system must exist (refer to Section 1,
“Creating a File System”), the volume where the file system exists must be activated, and the
supporting clustering and locking systems must be started (refer to Chapter 2, Getting Started
and Configuring and Managing a Red Hat Cluster. After those requirements have been met, you
can mount the GFS file system as you would any Linux file system.
To manipulate file ACLs, you must mount the file system with the -o acl mount option. If a file
system is mounted without the -o acl mount option, users are allowed to view ACLs (with
getfacl), but are not allowed to set them (with setfacl).
Usage
Mounting Without ACL Manipulation
mount BlockDevice MountPoint
Mounting With ACL Manipulation
mount -o acl BlockDevice MountPoint
13
">