Cutters Edge Chainsaw User Manual

Cutters Edge
Chainsaw
CE-2165-RS
Specifications
Location(s)
Use
Maintenance
Safety
2 cycle engine, 65.1 cc displacement, Compression ratio- 9.4:1, 5.06 HP,
Max engine speed- 12,500, Blade speed- 98.5 fps, Fuel- 50:1 gas/oil mix,
Bar chain oil lubricates the chain, Weight- 19.5 lbs, Height- 12”, Length37”, Carbide tipped wood cutting chain.
Driver side rear compartment. Cabinet #8
Ventilation, Forcible entry, Storm damage, Rescue
Remove gross debris from filters; wash/ oil if necessary, Remove and
clean depth gauge. Remove clutch cover and clean. Inspect and clean
blade; 3 missing consecutive teeth or 6 total teeth missing takes chain
OOS. Clean cutting arm and flip over when placing back on the saw. Make
sure area where bar chain oil comes out is clear. Reassemble saw, refuel,
and place in the ready position.
Visually inspect prior to use, set depth gauge prior to cut, Beware of
rotational and linear kickback, Wear proper PPE, Activate break after each
cut, Ensure bar chain oil remains filled to prevent overheating of the
blade/ material being cut.
☒ Pass
☐ Fail
☒ Pass
☐ Fail
☒ Pass
☐ Fail
☒ Pass
☐ Fail
☒ Pass
☐ Fail
Tactical Applications
Website: http://www.cuttersedge.com/protals/0/pdf/2100%20series%20op-maint_manual_2013.pdf
">