Carl Martin Dual Injection Owner s Manual


Add to my manuals
1 Pages

advertisement

Carl Martin Dual Injection Owner s Manual | Manualzz
Manual
As guitar players, we all have that moment where we
think, 'How can I do this and still remain analogue?' Once
we have achieved the 'ultimate tone, how can we boost
that same tone without changing the quality? What if we
want to boost the signal before your drive effect in order to
increase sustain, or have a boost in front of your gain
channel and another after the pre-amp in the effects loop?
Well, Carl thought about this for quite a while and is now
happy to introduce the super cool....'Dual Injenction'! Carl
took the high quality, transparent boost from the Hot
Drive'n Boost, and put two of them into one pedal. Each
has it's own level control and 'True Bypass' switch, plus
there is another toggle which switches the Dual Injection
between Serial and Parallel modes. In Serial mode, you
use the Input/Output 1 on the back of the pedal and place
the boost wherever you want in the signal chain. In Parallel mode, connect the Output 1 before your Drive or
Preamp, and then use the Input/Output 2 on the side of
the pedal to connect to your effects loop on the amp.
So, what does all this do for you? Well, the Dual Injenction gives you 4 different Boost settings...
1) Your normal set up either clean or with effects
2) Boost 1 engaged to a desired setting
3) Boost 2 engaged to a different setting than Boost 1
4) Both Boost 1 and Boost 2 engaged at the same time!
In Serial mode, you use the Input/Output 1 on the back of
the pedal and place the boost wherever you want in the
signal chain. In Parallel mode, connect the Output 1
before your Drive or Preamp, and then use the
Input/Output 2 on the side of the pedal to connect to your
effects loop on the amp.
Power Requirements
Battery: The Purple Moon does not accept batteries, as battery life will be too short.
Power consumption: max. 68 mA
Power supply: 9 V DC (regulated), 100 mA minimum, 2.1 mm female plug, center negative (-)
ATTENTION: Please Use DC Power Supply Only! Failure to do so may damage the unit and void the warranty.
Specifications
Input……………………….......... 1M Ohm
Output……………….................. 200 Ohm
S/N Ratio................................... 60 dB
Boost Max................................. 12 dB
Dimensions .............................. 120 (W) x 95 (D) x 56 (H) mm
4.72” (W) x 3.74” (D) x 2.2” (H)
Weight....................................... 420g/ 0.94lbs
Warranty: Carl Martin Research warrants the manufacturing, material and proper operation for a period of one year from date of purchase. Carl Martin will
replace defective parts, make necessary repairs or replace the unit at the discression of our technicians. The warranty applies only to the original purchaser of
this product, and excludes any damage or faulty operation resulting from misuse, neglect or unauthorized service.
Manufactured in China
East Sound Research Raadmandsvej 24
E-Mail: [email protected]
8500 Grenaa
Denmark
Phone: +4586325100

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement