User's Instruction
Paging
Only one Page can be performed at a time. If a conversation is already established another Page
cannot be performed until the existing conversation is over.
To initiate a Page do the following:
Step 1 - Press the Page/Answer button on any Interior Audio Station.
The Audio Station will emit two beeps. All other Interior Audio Stations will emit several rapid
beeps. The person performing the Page can now be heard on all the Interior Audio Stations.
To answer a Page do the following:
Step 1 - Press the Page/Answer button on any other Interior Audio Station.
The Audio Station will beep twice. At this point a private communication link is established
between the Audio Station used to perform the Page and the Audio Station that answered.
To end a Page do the following:
Step 1 - Either person can press the Page/Answer button on their Audio Station.
When the button is pressed the communication link is terminated.
To cancel a page do the following:
Step 1 - Press the Page/Answer button a second time.
If a Page was initiated and no one answered the person performing the Page can end the
Page by pressing the Page/Answer button a second time.
The WSS5908 Audio Interface Module auto detects the source of the loudest voice and
uses this to control the direction of conversation.
»
Do Not Disturb
To avoid receiving Pages, Door Box calls, Monitor or incoming phone calls a Station can be put on
‘Do Not Disturb’.
To put an Audio Station on Do Not Disturb do the following:
Step 1 - Press the Do Not Disturb button.
The red light on the Station will come on solid to indicate it is in Do Not Disturb mode.
To take a Station off Do Not Disturb do the following:
Step 1 - Press the Do Not Disturb button again.
The red light on the Station will go off and the Station will again be able to receive Pages,
Door Box calls and incoming telephone calls.
Westinghouse
Security Systems WSS5908
Audio Interface Module
Version 1.0
НН
Door Bell Answer
Your system may have a weather resistant Exterior Audio Station designed for door bell operation.
The Exterior Audio Station has only one button, a Call button. The Exterior Audio Station cannot
receive Pages, Monitor or receive incoming calls.
To initiate a call from the Exterior Audio Station do the following:
Step 1 - Press the call button on the Exterior Audio Station.
All the Interior Audio Stations will make a chime sound. Since there can be more than one
Exterior Audio Station on the system there are two different chime sounds available. This
will help you identify from which door the call is coming.
To answer a Door Bell call do the following:
Step 1 - Press the Page/Answer button on any Interior Audio Station.
The Audio Station will beep twice. At this point a private communication link is established
between the Exterior Audio Station used to perform the call and the Audio Station that answered.
Door Bell While on Page
If a Page is in progress when a Door Bell is pressed the two persons on the Page will hear the Door
Bell tone. Only the two persons on the Page will hear the Door Bell.
To answer the Door Bell while on Page do the following:
Step 1 - Either person can press the Page/Answer button on their Audio Station.
The Page will be disconnected and the person who pressed the Page/Answer button will
be immediately connected to the Exterior Audio Station that initiated the Door Bell.
Monitoring
The Monitor feature can be used to broadcast one Interior Audio Station to all the other Audio
Stations on premise. This is useful for monitoring a baby in a room.
To turn on the Monitor feature do the following:
Step 1 - Go to the Audio Station in the room you want to Monitor.
Step 2 - Press and hold the Do Not Disturb button for at least 2 seconds.
The Do Not Disturb light will begin to flash and the Station will be put in Do Not Disturb
mode. All sound in the room will be transmitted to all the other Interior Audio Stations.
To turn off the Monitor feature do the following:
Step 1 - Press the Do Not Disturb button once.
The station will return to the state it was in before the monitor feature was turned on. Do
Not Disturb (Light is ON) or Normal (Light is OFF).
Paging, Door Bell and Incoming Calls While Monitoring
interior Audio Stations can still be used to initiate/answer Pages, annunciate and answer the Door
Bell and ring and answer incoming phone calls. If a Page, Door Answer or telephone call answer is in
progress the Monitor feature will not operate until the conversation is ended.
Answering Incoming Calls :
When an incoming phone call is detected by the panel a ring tone will be generated on all Interior
Audio Stations.
To answer an incoming telephone call do the following:
Step 1 - Press and hold the Page/Answer button for 1 second.
When the button is pressed a private communication link is established between the
Interior Audio Station the button was pressed on and the incoming call.
To hang up a telephone call do the following:
Step 1 - Press the Page/Answer button for 1 second.
When the button is pressed the Audio Station will hang up the call. If the person calling
hangs up the Audio Station will hang up after 30 seconds of silence.
Answering an Incoming Call While Paging
If a Page is in progress when an incoming call is detected the two persons on the Page will hear the
ring tone. Only the two persons on the Page will hear the ring.
To answer an incoming call while on Page do the following:
Step 1 - Either person can press the Page/Answer button on their Audio Station.
The Page will be disconnected and the person who pressed the Page/Answer button will
be immediately connected to the incoming call.
Transferring an Answered Call to the In-house Phones
Once you have answered a call at the interior Audio Station, the call can be transferred to an in-
house phone.
To transfer the call:
Step 1 - Pick up an in-house phone and press the [#] key.
When the in-house phone is picked up and a [#] is pressed the phone call will be
transferred from the intercom station to the in-house phone.
To hang up the call:
Step 1 - Simply hang up the phone hand set as you normally would.
Call Waiting
To answer a second call while on line with the first call, simply press the Page/Answer button. This
will function like pressing a telephone off-hook switch or “Flash” button. To return to the first call,
simply press the Page/Answer button again.
TT >;
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by the manufacturer could void your authority to use this equipment.
This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the
manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply
with the limits for Class B device in accordance with the specifications in Subpart “B” of Part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference in any residential installation. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause interference to television or radio
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the integference
by one or more of the following measures:
* Re-orient the receiving antenna
* Relocate the alarm control with respect to the receiver
* Move the alarm control away from the receiver
* Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The
user may find the following booklet prepared by the FCC helpful: “How to Identify and Resolve Radio/Television
Interference Problems”. This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402,
Stock # 004-000-00345-4.
Westinghouse Security Systems
1-800-654-6770
Printed in North America 29001743 RO
">
