Sartorius YDP30 Operating instructions

Below you will find brief information for Data Printer YDP30. This document provides essential information for setting up, operating, and maintaining the YDP30 data printer. It covers unpacking, printer overviews, setup procedures (including media loading), LED and button functions, troubleshooting, and maintenance instructions. It also provides specifications and information about accessories.

PDF
Document
Sartorius YDP30 Data Printer: AI Chat & PDF Download | Manualzz

Advertisement

Advertisement

/

Advertisement

Key features

  • Thermal transfer & direct thermal printing

  • Max print width: 54 mm (2.13")

  • RS-232 & USB interfaces

  • Supports outside wound media

  • Adjustable media holders

  • Peel-off mode capability

Frequently asked questions

Check if the interface cable is well connected. Also, ensure the serial port settings are consistent between the host and printer.

Open the top cover, adjust the media holders to the label roll width, place the roll between the holders, and guide the paper through the media guides and under the media sensor.

A flashing red LED indicates a printing error, such as paper empty, paper jam, or memory error. Check the printer for a paper issue first.

User questions

R M

John R.

How to load paper into the device?

To load paper, open the upper cover of the printer by pulling the opening levers on both sides and lifting the cover. Adjust the media holder to the width of the label roll. Place the roll between the brackets and lock them on the core. The media holder is suitable for 1-inch and 1.5-inch media cores; rotate the upper part of the label holder 180° to the right as needed.

Preparing document for printing…
0%