GE Profile Side-By-Side PSF26PGWBB, PSS26PSWSS, PSC25PSWSS, PSW26RSWSS refrirator Technical Service Guide

Below you will find brief information for refrigerator Profile Side-By-Side PSF26PGWBB, refrigerator Profile Side-By-Side PSS26PSWSS, refrigerator Profile Side-By-Side PSC25PSWSS. This Profile Side by Side refrigerator features: - Separate freezer and fresh food evaporators - No damper/air inlet assembly in the fresh food section for more usable space - ClimateKeeper for greater fresh food humidity - 20% less freezer defrost - 3-way valve to direct refrigerant flow - Near silent operation - Precise Fill water dispensing - QuickFreeze, Quick Ice, TurboCool, CustomCool functions.

PDF
Document
GE Profile Side-By-Side PSF26PGWBB, PSS26PSWSS, PSC25PSWSS Technical Service Guide | Manualzz

Advertisement

Advertisement

/

Advertisement

Key features

  • Separate freezer and fresh food evaporators

  • New integrated dispenser with LED lighting

  • QuickFreeze feature

  • Quick Ice feature

  • LCD screen control

  • TurboCool feature

  • Precise Fill technology

  • CustomCool feature

  • ClimateKeeper technology

Frequently asked questions

These refrigerators feature separate freezer and fresh food evaporators with independent cooling, integrated dispenser with LED lighting, child lock, and door alarm combined with LCD screen, QuickFreeze Feature, Quick Ice feature, TurboCool feature, Precise Fill technology and CustomCool feature.

You can use the touch screen control to change the temperature of the refrigerator and freezer compartments. You can also use the LCD screen to adjust the temperatures.

Place food (wrapped in plastic wrap) on the QuickFreeze plate. Turn the feature on via the LCD controls. QuickFreeze can operate for 2.5 hours up to 3.25 hours depending on the weight of the food or until you manually turn the feature off.

Use the Quick Ice feature to speed up ice production. When this feature is turned on, the freezer fan runs continuously for 48 hours, or until the feature is turned OFF. During this period, ice production will increase up to 40%.

Use TurboCool when adding a large amount of food to the refrigerator compartment, putting away foods after they have been sitting out at room temperature or when putting away warm leftovers. It can also be used if the refrigerator has been without power for an extended period.

This feature allows you to choose a precise amount of water (cups, ounces, pints, or liters) that you would like dispensed.

Use this feature to quickly chill items, thaw items, or hold the pan at a specific temperature. The pan is tightly sealed to prevent temperature fluctuations in the rest of the refrigerator.

User questions

I L

Patricia I.

Which pin on the control board is the defrost thermostat connected to?

The defrost heater is connected to the main control board via connector J9, pin 1. This pin provides switched L1 voltage to the defrost circuit.

E I

Robert E.

How to enter the diagnostic mode on system?

There are two diagnostic modes. One is accessed through the LCD screen by pressing and holding the HOME, CRUSHED, and WATER pads until the SELF DIAGNOSIS screen appears. The other diagnostic mode is accessed using the diagnostic aid kit by pressing both the freezer temperature (COLDER and WARMER) pads and the refrigerator temperature (COLDER and WARMER) pads simultaneously for approximately 3 seconds until blinking '0's appear in both displays. Remove fingers within 5 seconds and press any middle pad to lock in the test mode.

E I

Robert E.

How can a defrost cycle be manually initiated on this system?

A defrost cycle can be manually initiated using the diagnostic mode. By entering the diagnostic mode and using the appropriate display numbers, the defrost cycle can be toggled on. Note that the defrost test must be entered again to toggle the defrost heater off at the end of the test. The heater will not activate if the evaporator thermistor is above 70°F (21°C).

I D

Robert I.

How do I remove the freezer evaporator cover?

To remove the freezer evaporator cover, follow these steps: 1. Remove the 4 hex-head screws that hold the freezer evaporator cover in place. 2. Lift the cover up to clear the front lip of the drain trough, then lower the cover to release it from the 2 recessed slots. 3. Pull the left side of the cover out and rotate the harness grommet clockwise to release it from the cover. 4. Carefully remove the cover from the freezer.

I L

Patricia I.

How to troubleshoot defrost issues?

To troubleshoot defrost issues, the LCD screen's self-diagnosis mode can be used to test components. Enter the self-diagnosis mode by pressing and holding the HOME, CRUSHED, and WATER pads. Select the SOFTWARE VERSION, FACTORY TEST, or HMI TEST options and follow the on-screen instructions. A diagnostic aid kit may help in functionally testing individual components.

Preparing document for printing…
0%