OPERA TING INSTRUCTIONS
Versión en español
Si desea obtener una copia en español de estas
Instrucciones de Funcionamiento, sírvase escribir a la dirección que se incluye a continuación. Solicite la
P/N 131722100.
Spanish Owner's Guides
Frigidaire Company
P. O. Box 9061
Dublin, Ohio 43017-0961
2. Prepare items for washing.
3. Pretreat stains and heavy soil.
4. Add the measured amount of detergent to the washer before adding the laundry load.
5. If desired, add liquid bleach to the Bleach
Dispenser.
6. Add the laundry load to the wash tub.
Before Operating Your Washer
Read your washer Owner's Guide. It contains important safety and warranty information. It also contains many suggestions for obtaining the best results from your washer.
7. If desired, add liquid fabric softener to the Fabric
Softener Dispenser.
8. Set washer controls according to type, size, and soil level of each load:
Wash/Rinse Temperature
Agitate/Spin Speed
Load Size
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your washer Owner's Guide before operating this appliance.
See Controls and the Control Settings Chart (reverse side) for more information on suggested water temperatures, agitate/spin speeds, and water level.
Operating Steps
1. Sort laundry into loads that can be washed together.
9. Push in the cycle selector knob and turn it
clockwise to the desired wash cycle. See Cycle
Selection for cycle descriptions and the Control
Settings Chart for suggested cycle settings.
Printed in U. S. A.
10. Start the washer by closing the lid and pulling
out the cycle selector knob. The washer will operate with the lid open; however, the tub will not spin unless the lid is closed. To stop the washer, push in the cycle selector knob. To change a cycle, push in the cycle selector knob and turn it clockwise to the desired setting. Pull out the knob to restart washer.
11. Remove items when the cycle is completed. As a safety measure, the lid will AUTOMATICALLY
LOCK during the spin portion of each cycle. The lid will automatically unlock approximately 1 minute after the tub stops spinning.
Cycle Selection
For best results, follow the fabric care label directions on items to be washed. Check the Control Settings Chart if the care label is not available.
The Regular, Perm Press and Knits & Delicates cycles provide a spray rinse during the first spin, followed by a deep rinse and a final spin.
Regular Cycle
Up to 15 minutes of wash agitation for most fabrics.
(continued, reverse side)
P/N 131722000 (9711)
Cycle Selection
(continued)
Perm Press Cycle
Up to 12 minutes of wash agitation for cottons and blends with a no-iron finish.
Controls
Select the desired control settings according to load size, fabric type and degree of soiling. See Control Settings
Chart below or Washing Procedures in your Owner's
Guide for detailed information on choosing control settings.
Knits & Delicates Cycle
Six minutes of wash agitation for the gentle care of knit and delicate items.
WASH/RINSE TEMPERATURE determines water temperatures for washing and rinsing.
Soak & Prewash Cycle
• Soak — The Soak setting can be used to treat heavily soiled or stained items. It provides 2 minutes of agitation and 12 minutes of soaking time, then advances to the Prewash portion of the cycle. Use the amount of detergent recommended for a normal wash cycle. For colorfast items, bleach or a soaking agent may also be used. Follow manufacturer's directions on the product label.
AGITATE/SPIN SPEED determines speeds for the agitation and spin portions of each cycle.
LOAD SIZE determines the amount of wash and rinse water used for the wash load. To increase the water level after the wash cycle begins, turn the Load Size control to Reset and hold. When water begins to enter the tub, turn the control to the desired setting.
Control Settings Chart
Locate fabric type and read across guide for suggested wash and rinse temperatures, wash cycle and time setting, and agitate/spin speeds. This is only a general guide. For best results, follow label directions on specific items to be washed.
Fabric Type Temperature (Wash/Rinse) Wash Cycle and Setting Agitate/Spin Speed
REGULAR
Heavily Soiled
Colorfast & White
Cotton & Linen Hot Cold Regular - 15 Normal/Fast
• Prewash — When soaking is not necessary, the
Prewash setting can be used alone to help remove protein-based stains such as milk, grass and blood and to help loosen soils before washing. During
Prewash, the washer will agitate the load for 2 minutes, then drain, spin and shut off. Use the amount of detergent and other laundry products recommended for a normal wash cycle.
Normally Soiled
Colorfast & White
Cotton & Linen
Lightly Soiled
Noncolorfast
Bright Colors
All Fabrics
Warm
Cold
Cold
Cold
Regular - 8 to 12
Regular - 4 to 8
Normal/Fast
Normal/Fast
Note:
• The Soak water temperature is the same as the rinse water temperature selected; the Prewash water temperature is the same as the wash water temperature selected. To avoid setting protein stains, select cold water.
• Select wash/spin speeds appropriate for the items being soaked or prewashed.
• Soak and Prewash should always be followed by a complete wash cycle using the recommended amount of detergent.
PERMANENT PRESS
White or
Heavily Soiled
Colored or
Lightly Soiled
KNITS/DELICATES
Knitted Fabrics
Delicates
Washable Woolens
Hot or
Warm Cold
Warm or Cold Cold
Cold
Cold
Warm
Cold
Cold
Warm
Perm Press - 8 to 12
Perm Press - 4 to 8
Knits & Delicates - 6
Knits & Delicates - 6
Knits & Delicates - 6
Normal/Slow
Normal/Slow
Gentle/Fast
Gentle/Slow
Gentle/Fast
P/N 131722000 (9711)