Optical Mouse
Instruction Manual
97986 www.jascoproducts.com
Revision 4
2
CONNECTING YOUR MOUSE
1. Turn off the power to your computer. (You must
Shut Down and Turn Off your computer before connecting or disconnecting any PS/2 device.
Failure to do so could damage your computer.)
2. Disconnect the existing mouse.
3. Connect your new GE Optical Mouse to the round mouse PS2 port on your computer.
(Usually this port is green.)
4. Turn on your computer and start your Operating
System.
5. Move the mouse to ensure there is a good connection.
If your mouse does not work properly, please check that all connections are secure and the cable is free of twists. After following these steps, please contact Jasco product support at www.jascoproducts
3
FIVE YEAR LIMITED WARRANTY
Jasco Products Company warrants this product to be free from manufacturing defects for a period of five years from the original date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or incidental damage to other products that may be used with this unit. This warranty is in lieu of all other warranties express or implied. Some states do not allow limitations on how long an implied warranty lasts or permit the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you. This warranty gives you specific rights, and you may also have other rights which vary from state to state. If unit should prove defective within the warranty period, return prepaid with dated proof of purchase to:
Jasco Products Company
10 E. Memorial Road
Oklahoma City, OK 73114
4
FCC STATEMENT
Notice: Federal Communications Commission (FCC) requirements, Part 15
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
•
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
• that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes of modifications not expressly approved by the grantee of this device could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC,
10 E. Memorial Road, Oklahoma City, OK 73114.
5
