Panasonic KX TS5 Corded Phone

Panasonic
Integrated Telephone System
Model No. KX Polos,
KX-TS5-W
Fulse-or-tone dialing capability
Operating Instructions
= - a H: TE Tee a 1 "E = Na pa PT. CRE = oe
KX-T55-8
PLEASE READ BEFORE USE AND SAVE.
Contents by Section
1 Getting Started 4 Things You Should Know
2 Making/Answering Calls 5 Referencia rápida (Spanish)
3 Special Features
tn nn ee
| Attach your purchase receipt here. |
For your future reference
serial No. Date of purchase
(found on the bottom of the unit)
Mame and address of dealer
For product service
éCall 1-800-211-PANA(7262) or 1-800-833-9626 for the location of
an authorized servicenter,
When you ship the product
Carefully pack your unit, preferably in the original carton.
es Attach a letter, detailing the symptom, to the outside of the
carton.
Symptom
#5end the unit to an authonzed servicenter, prepaid and adequately
insurad.
*Do not send your unit to the Panasonic Consumer Electronics
Company listed below or to executive or regional sales offices.
These locations do not repair consumer products,
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, Mew Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infanteria, Km. 9.5, San Gabriel Industrial Park
Carolina, Puerto Rico 00985
Printed in Malaysia PQQAX11903ZA-BM FF0358KM0 (D)
Getting Started Section 1
1-A Accessories 1-B Location of Controls
OO Handset .................... one
DIALING MODE Selector (1 -C)
TONE) Button (3-B)
RINGER Selector (1-С)
A =
x
|
ul!
VOLUME CJ), Buttons (2-A)
| Button (3-A)
e To order accessories, call
1-800-211-PANA(7262). Button (2-A)
1-C Settings
/ y Connect the handset cord.
Fasten the cord to prevent
it from being disconnected.
Connect the telephone line cord,
Single-Line _. O then lift the handset to confirm the
Telephone Jack (RJ11C) dial tone
вже Set the DIALING MODE selector to
| TONE.
>= sa _ e1f you cannot dial, set to PULSE.
Telephone > К > IALING MODE
Line Cord || ES DIALING MODE Selector bv —
le Я UNER Selector TT
TONE 7 “PULSE
Set the RINGER selector to HIGH,
LOW or OFF.
eWhen set to OFF, the unit will not ring.
Handset RINGER
|r me анну
Handset Cord
Ju
RIGA "oy OFF
Making/Answering Calls Section й
2-A Making Calls
To redial the last number
Lift the handset. y» Press (REDIAL |.
To select the receiver
1 Lift the handset.
Dial a telephone number.
elf you misdial, hang up and start volume (6 levels) while
from step 1. talking
o To increase the volume, press
When finished talking, VOLUME (AN).
hang up. To decrease, press VOLUME M.
eFach time you press the button,
the volume level will change.
e After hanging up, the volume will
2.83 Answering Calls | return to middle volume.
VOLUME (\/),
When the unit rings,
lift the handset.
When finished talking,
hang up.
Special Features
3-A For Call Waiting Service Users
Press (FLASH | if you hear a call-waiting tone while talking.
e The first call is put on hold and you can answer the second call.
e To return to the first caller, press (FLASH) again.
=
Coo
PO
Gon CS
Flo 3-B Temporary Tone Dialing
| (For Rotary or Pulse Service Users)
Press | TONE] before entering access numbers which require tone
TONE dialing. :
® The dialing mode changes to tone. You can enter numbers to
access answering services, electronic banking services, etc.
When you hang up, the mode will return to pulse.
e Access numbers entered after pressing will not be
included when redialing.
TI
Г"
>
о
aL
Things You Should Know Section 4
4-A Wall Mounting
The unit can be mounted on a wall phone plate.
Connect the
telephone line
cord to the unit.
To temporarily set the
handset down during a
conversation, place it
as shown here.
{ Ma h
МА 7
«<
ña
Connect the
telephone line
cord to Single-
Line Telephone
Jack. Mount the
unit, then slide
down.
4-C Helpful Information
4-B Before Requesting Help
e Environment—do not place the unit in room where the
Problem Remedy temperature is less than 5°C (41°F) or greater than 40°C (104°F).
Allow 10 cm (4”) clearance around the unit for proper ventilation.
Avoid excessive smoke, dust, mechanical vibration, shock, or
The unit does not Check the settings (1-C). direct sunlight.
work. :
e Routine care—wipe the unit with a soft cloth. Do not use
benzine, thinner, or any abrasive powder.
The call cannot be ®Check whether the DIALING elf there is any trouble—disconnect the unit from the telephone
connected even MODE selector setting is correct line and connect a known working phone. If the known working
you dialed or not (1-C). phone operates properly, have your unit repaired by one of the
authorized Panasonic Factory Service Centers. If the known
working phone does not operate properly, consult with your
telephone company.
correctly.
The unit does not ®The RINGER selector is set to
ring. OFF. Set to HIGH or LOW (1-0).
if you cannot solve Call our customer call center at
your problem. 1-800-211-PANA(7262).
Referencia rapida
5-A Colocación
Sujete el cable para
impedir que se
desconecte.
||
| y Selector DIALING MODE
a | - Selector RINGER
Toma de teléfono de |
línea única (RJ11C) O
br
Cordón de
línea telefónica [| ‚LG
Microteléfono
Cordón de
microteléfono
1 Conecte el cordón del microteléfono.
2 Conecte el cordón de línea telefónica,
y luego levante el microteléfono para
confirmar el tono de discado.
3 Ponga el selector DIALING MODE en
TONE.
e Si no puede discar, póngalo en PULSE.
4 Ponga el selector RINGER en HIGH,
LOW u OFF.
e Cuando lo ponga en OFF, la unidad no sonará.
| 5-B Para hacer llamadas
| Levante el microteléfono.
2 Disque un número telefónico.
3 Cuelgue cuando termine de conversar.
5-C Para contestar llamadas
Cuando suene la unidad, levante el
microteléfono.
7 Cuelgue cuando termine de conversar.