Trendnet TV-IR500 6mm F/1.8 1/3” CS-Mount IR Lens Quick Installation Guide

TV-IR500 Hardware Installation Spacer & Screw
Note:
1. The IR filter ring, spacer, screws and washers are only necessary if you plan on mounting
the TV-IP512P/TV-IP512WN into the TV-H500/TV-H510. — |
2. If you are using the TV-IP512P/TV-IP512WN, please verify the hardware version. The 1. 36 the following farms ready. Spacer +
hardware version of the TV-IP512P/TV-IP512WN must be V1.1R or V1.3R in order to work black plastic mounting bracket.
properly with the IR lens (TV-IR500).
IR Filter Ring
2. Insert the screw from the bottom of the
black mounting bracket. Than insert the
washer and the spacer on the other side
of the black plastic mounting bracket.
1. Attached the IR filter ring to the TV-IR500.
2. Insert the TV-IR500 into the IP camera.
Turn the TV-IR500 clockwise to secure
the lens.
4 a к | 3. Inset the screw on the bottom of the IP
- camera. Use pliers to secure the screw to
the IP camera.
3. Insert the male power plug to the IP WENT
camera.
4. Follow the instructions in the
TV-H500/TV-H510 to complete the
installation of the TV-IP512P/TV-IP512WN
into the camera enclosure.