EdgeStar | User manual | IP210SS Owner`s Manual

Add to my manuals
13 Pages

advertisement

EdgeStar | User manual | IP210SS Owner`s Manual | Manualzz

IMPORTANT SAFETY INSTRUCTIONS

…………………………………………………1

 

PREPARING YOUR ICE MAKER FOR USE

 

IMPORTANT SAFETY TIPS.……………………………………………………………….2

 

GETTING TO KNOW YOUR UNIT

…  …  …  …  …  …  …  …  …  …  … 

…  … 

… .

.

.  3 

 

OPERATING PROCEDURES & MAINTENANCE

 

UNPACKING YOUR ICE  MAKER ..………….…………………………………………...4 

CONNECTING YOUR ICE  MAKER……………….……….……………………………..4 

CLEANING AND MAINTAINING  YOUR ICE MAKER….……………………………….4

 

USING YOUR ICE MAKER

……………….……..………………………………………...5 

TROUBLESHOOTING..……………………….……………………………………………6

 

TECHNICAL SPECIFICATIONS &  CIRCUIT DIAGRAM

…..……………..….………..8

 

WARRANTY

…………………………..……….………………………………………….…9

 

9

DANGER

 

You can be killed or seriously injured if you don’t immediately 

 

All  safety  messages  will  tell  you  what  the  potential  hazard  is,  tell  you  how  to  reduce  the  chance of injury, and tell you what can happen if the instructions are not followed.

 

1

IMPORTANT SAFETY TIPS

 

When  using  electrical  appliances,  basic  safety  precautions  should  be  followed  to  reduce  the  risk  of  fire,  electric  shock,  and/or  injury  to  persons  or  property.  Read  all  instructions  before  using any appliance. 

Do not operate this or any other appliance with a damaged cord. 

Connect to properly polarized outlets only. No other appliance should be plugged into the  same outlet. Be sure that the plug is fully inserted into the receptacle. 

Do not run cord over carpeting or other heat insulators. Do not cover the cord. Keep cord  away from traffic areas, and do not submerge in water. 

We  do not  recommend the  use  of  an  extension cord, as it  may overheat  and  become  a  fire risk. If you must use an extension cord, use a cord of No.14 AWG minimum size and  rated for no less than 1875 watts. 

Unplug the ice maker before cleaning it or making repairs. 

Exercise caution and use reasonable supervision when appliance is used near children. 

Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or  explosion. 

Do not tip over. 

If the ice maker is brought in from outside in wintertime, give it a few hours to warm up to  room temperature before plugging it in.

 

2

1. Cover: Features a transparent window for interior visibility. 

2. Ice shovel. 

3. Control  Panel: Easy to use, with touch controls. 

A. Ice­full light. 

B. Ice size indicators: Small, Medium, and Large. 

C. Ice size selector button. 

D. Add water light: when lit, add water. 

E. Power indicator. 

F. Power button. 

4. Foot 

5. Water drain cap: For draining water from water reservoir. 

6. Air vent. 

Note: Ice scoop not shown. 

4

 

3

UNPACKING YOUR ICE MAKER

 

CONNECTING YOUR ICE MAKER 

CLEANING AND MAINTAINING YOUR ICE MAKER

 

4

1.  Select the size of the ice cube by pressing the “Select” button. If the room temperature is  lower than 60°F, it is best to select the small or medium ice size, otherwise the ice cubes  might stick together. 

2.  Open the cover, remove the ice basket and pour water into tank. 

Keep water level below the level mark. 

3.  Press “Power” on the control panel to begin the ice making cycle. 

4.  The  ice  making  cycle  lasts  6  to  15  minutes,  depending  on  the  size  of  the  ice  cubes  selected. 

5.  While the ice  maker is on, verify  the water level periodically. If the  water  level is too low,  the ice maker will stop automatically, and the “Water” indicator will turn on. 

Press the “Power” button, fill the unit with water, and press “Power” again. 

Allow the refrigerant inside the compressor at least 3 minutes to settle before restarting. 

6.  The ice maker automatically stops working when the ice basket is full. 

7.  Change  the  water  in  the water reservoir  every 24  hours to  ensure a  reasonable  hygiene  level. 

If the ice maker will not be used for an extended period of time, you should drain the water  from the reservoir and wipe out the inside of the unit.

 

5

TROUBLESHOOTING

 

Issue 

No power to the unit.

 

Solution 

Check to make sure the power cord is plugged  in 

Check the control panel for any lights or if there  is any movement with any components of the  unit such as the ice case or water pump. If there  is no light or no movement, contact EdgeStar  support.

 

When the ice maker is plugged in, the power  light may blink until you push the power button  to turn on the unit. 

Only  the  power  and/or  ice  cube  size  lights  are  on,  unit  is  not  working  and  does  not  respond  to  buttons  pushed  on  the  control  panel.

 

After pushing the power button and making  ice  cube  selections,  the  ice  maker  does  nothing

Ice case moves back and forth but does not  stop in the water fill position

Unit  goes  through  the  ice  making  process,  but  no  ice  is  produced,  or  ice  cubes  are  very small.

 

If you push the power button, but the unit does  not respond, then the probable cause is a faulty  control panel, and needs to be replaced. 

Contact EdgeStar support.

 

Contact EdgeStar support.

 

Contact EdgeStar support.

 

Compressor makes a knocking noise

 

Check to see if the ice maker is being used in  proper ambient temperature. If unit is run in a  room that is particularly hot at times, such as  kitchen or laundry rooms, Please move the unit  to a different, cooler room and try again. 

If ice maker is being used in proper ambient  temperatures, then check to see if the fan on the  side of the unit is working during the cycle. If not,  then the fan needs to be replaced as it is not  drawing the heat off the coils. Contact EdgeStar  support.

 

Make sure the unit is sitting level 

If the unit is sitting level, then contact EdgeStar  support

 

When the unit tries to dump the ice, the ice  case and shovel jam.

 

The ice case hinges or the ice shovel plastic  tabs (on older models) are broken and need to  be replaced.

 

6

The  ice  maker  has  a  funny  smell  or  the  ice  that  is  being  produced  has  an  unappealing  taste.

 

Clean  the  machine  out  with  a  mild  soapy  solution and a soft cloth 

The “add water” light is on even though the  machine is full of water.

 

Ice maker freezes one big block of ice  instead of individual cubes.

The unit is leaking.

 

 

Add a tablespoon of vinegar to the water in the  reservoir  and  then  run  a  few  batches  of  ice.   After removing the vinegar ice and water,  run  a  few  more  cycles  with  regular  water. 

Remove  this  water  and  ice.  The  machine  should  then  be  free  of  a  bad  smell  and  you  should be able to produce better tasting ice.

 

Your  water  may  not  have  enough  impurities 

(distilled,  reverse  osmosis  [RO],  purified,  etc.)  in  it.  Add  a  pinch  of  salt  to  the  distilled  water. 

This  will  add  impurities  to  the  water  which  will  allow the machine to detect the water. 

The water uptake  filter may be clogged (at the  bottom  of  the  lower  water  reservoir).  Using  a  flathead screwdriver to pry it out, clean the filter  and replace.

 

If  the  ambient  temperature  in  the  room  is  less  than  60  degrees,  use  only  the  small  and  medium ice cube size settings. 

If  the  ambient  temperature  in  the  room  is  normal, the compressor may be faulty. Contact 

EdgeStar support

 

If  there  is  a  steady  drip  coming  from  the  machine,  the  drain  plug  may  be  loose  or  a  hose  may  have  been  damaged.  If  the  drain  plug  is  securely  attached,  contact  EdgeStar  support 

If the machine is leaking when water is poured  into the lower water reservoir, a hose may have  become dislodged. Contact EdgeStar support. 

Contact EdgeStar support

 

The  evaporator  coils  are  not  freezing/The  evaporator  coils  are  not  releasing  the  ice/Only  half of the evaporator coils are freezing. 

7

This EdgeStar product is warranted to be free  from  defective  workmanship  and  materials for  the first year following the date of original purchase. Replacement parts will be supplied free of  charge for the first year following the date of original purchase. Labor will be performed free of  charge for the first 90 days following the date of original purchase.

 

WHAT IS COVERED

 

This warranty applies to the original purchaser only, and only covers defects in workmanship  experienced  during  operation  of  the  product  under  normal  service,  maintenance,  and  usage  conditions. This warranty applies to the purchase and use of this product in residential settings  within the United States of America.

 

WHAT IS NOT COVERED

 

The following limitations apply to the coverage of this warranty: 

Optional  accessories,  attachments,  and  appearance  items  are  excluded  from  warranty  coverage, as is shipping damage, and any damage caused by improper voltage or any other  misuse, including abnormal service, handling, or usage. 

This warranty does not cover normal wear and tear on parts or replacement of parts designed  to be replaced, e.g. filters, etc. 

This warranty does not cover service trips to deliver, pick­up, repair, or install the product, or to  instruct in proper usage of the product. 

Damages  or  operating  problems  resulting  from  abuse,  operation  outside  environmental  specifications, uses contrary to instructions provided in the owner’s manual, accidents, vermin,  fire, flood, improper installation, unauthorized service, acts of God, unauthorized installation or  modification, or commercial use are excluded from warranty coverage. 

Damage or loss of items stored inside the appliance are excluded from warranty coverage. 

This  warranty  does  not  cover  labor  incurred  91  days  or  more  after  the  date  of  original  purchase. 

This warranty does not cover use of EdgeStar products in commercial settings.

 

DESCRIPTION OF WARRANTY SERVICE

 

All  defective  product  components  covered  by  this  warranty  will  be  repaired  or  replaced,  at 

EdgeStar’s  option,  free  of  charge  on  a  mail­in  basis  to  EdgeStar’s  authorized  repair  facility  during the first 90 days from the date of original purchase. 

All  defective  product  components  covered  by  this  warranty  will  be  repaired  or  replaced,  at 

EdgeStar’s  option,  on  a  mail­in  basis  to  EdgeStar’s  authorized  repair  facility  during  the  time  period beginning on the 91  st  day from the date of original purchase and ending one year from  the date of original purchase. During this time period, parts will be supplied free of charge, but  labor charges will apply. 

All replacement parts and units will be new, remanufacturered, or refurbished. 

All  products  and  components  replaced  by  EdgeStar  under  warranty  service  become  the  

9

property of EdgeStar.

 

OBTAINING WARRANTY SERVICE

 

Contact  EdgeStar  for  troubleshooting  assistance  and  warranty  service  authorization  at 

1­866­319­5473. Please have your order receipt available to confirm the date of purchase. 

Once  an  EdgeStar  authorized  representative  has  confirmed  that  your  product  is  eligible  for  warranty service, the product must be returned to an EdgeStar authorized repair facility. 

The  purchaser  is  solely  responsible  for  prepaying  all  shipping  related  costs  to  and  from  the  repair facility. 

EdgeStar  is  not  responsible  for  damage  resulting  from  shipper  mishandling  or  improper  packaging. 

Do not return defective product to the place of purchase. 

THIS  WARRANTY  IS  IN  LIEU  OF  ANY  OTHER  WARRANTY,  EXPRESS  OR  IMPLIED, 

INCLUDING  WITHOUT  LIMITATION,  ANY  WARRANTY  OF  MERCHANTABILITY  OR 

FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS 

REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD 

ABOVE.  NEITHER  THE  MANUFACTURER  NOR  ITS  DISTRIBUTORS  SHALL  BE  LIABLE 

FOR ANY INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES 

OF  ANY  NATURE,  INCLUDING  WITHOUT  LIMITATION,  LOST  REVENUES  OR  PROFITS, 

OR  ANY  OTHER  DAMAGE  WHETHER  BASED  IN  CONTRACT,  TORT,  OR  OTHERWISE. 

SOME STATES DO NOT ALLOW THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL 

DAMAGES,  SO  THE  ABOVE  EXCLUSION  MAY  NOT  APPLY  TO  YOU.  THIS  WARRANTY 

GIVES  YOU  SPECIFIC  LEGAL  RIGHTS.  YOU  MAY  HAVE  OTHER  RIGHTS  THAT  VARY 

FROM STATE TO STATE.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement