Unitech Scanners User Manual

MS860 Bluetooth Setting
Cradle Bottom
Function
• Reset Scanner Barcode
– Scanner Rest
• Pair
– Link Setting
• SCM
– No function right now
• Interface
– The interface of Link setting
Link with no signal
• Cradle Side:
The left LED is Red light.
• Scanner Side:
The LED is Green light
Bluetooth Setting (mode 1)
1. The Scanner power ON and scan the the
“Reset Scanner Barcode” (on Cradle bottom).
2. Link success:
The Cradle’s LED (left) and Scanner LED will
be light out
3. If it is still not link please run the mode 2
Bluetooth Setting (mode 2)
1. Confirm the link range between Scanner and
Cradle and no other Scanner in vicinity.
2. Press the “Pair “ of Cradle bottom and then start
to scan (the LED will be flashed Green light.
3. Setting success (LED status)
Cradle Side: the left will be light out
Scanner Side: No light
Interface setting
•
There are tree buttons in Cradle bottom
(“1”, ”2” , ”3”)
1. USB
2. RS232
3. Keyboard Wedge
Setup the button to correct interface
">