BASIC INSTALLATION INSTRUCTIONS FOR BELKIN SURGE PROTECTORS
Power Connections
- Your Belkin Surge Protector should only be plugged into a grounded outlet. All connected equipment should be plugged directly into your Belkin
Surge Protector. Using any extension cord in conjunction with a Belkin Surge Protector will void all Belkin warranties.
Phone/Fax/Modem/Network Connections
Certain Belkin Surge Protector models come with phone/fax/modem surge protection. Instead of running a connection directly from your
phone/fax/modem to the wall jack, you must pass the connection through the protected jacks on your Belkin Surge Protector.
e Connect your phone/fax/modem/network line from your wall outlet to the “Input” jack on the Surge Protector. Connect an RJ11 phone cord
into the “Output” jack on the Surge Protector, and connect the other end of the phone cord to the phone/fax/modem jack of the device you
want to protect. |
- If you fail to connect the phone/fax/modem protection, and/or network protection, the Connected Equipment Warranty will not cover your
connected equipment. Most modem damage can be prevented if you take the time to connect the phone/fax’ modem protection.
Coaxial Cable Connections
Certain Belkin Surge Protector models come with coaxial cable surge protection. Instead of running a connection directly from your DSS
receiver/TV/VCR/cable box to the wall jack, you must pass the connection through the protected “F” connectors on your Belkin Surge Protector.
* — Connect your incoming cable/antenna/DSS line to the “Input F” connector on the surge protector. Connect a coaxial cable into the “Output
F” connector on the Surge Protector, and then connect the other end of the coaxial cable to the “Input F” connector of the device you want
to protect.
+ |fyoufail to use the coaxial cable protection, the Connected Equipment Warranty will not cover your connected equipment. Most TV/VCR
damage can be prevented if you take the time to connect coaxial cable protection.
PHONE CONNECTION COAXIAL CONNECTION
Surge Protector Surge Protector
Phone Phone Coax Coax Cable
Input Output Cable Input i
To Wall Phone To Phone/Fax/Modem To Wall, DSS, or other | To TV, VCR, Receiver,
Outlet Device Coaxial Outlet or Other Coaxial Input
PHONE CONNECTION WITH BUILT-IN SPLITTER
Surge Protector
Phone Phone
Input Output
A NA
\
ES
To Wall Phone To Phone/ To Phone/
Outlet Fax/Modem Fax/Modem
Indicator Lights
e The“ protected” light should be on when the power switch is turned on. If this light goes out at any time, it means that your Surge Protector
Was sacrificed to protect your equipment and should be replaced. Please contact Belkin for a free replacement Surge Protector
in this case.
« The“grounded” light should be on when the power switch is turned on. If this light does not come on when you plug in your Belkin Surge
Protector, you have a ground-wiring problem and you should contact an electrician to properly ground the outlet. Connecting a Belkin Surge
Protector to an improperly grounded outlet will void all Belkin warranties. If your home is properly grounded and the Surge
Protector grounded indicator light burns out, please contact Belkin for your free replacement.
Belkin International, Inc. « 501 West Walnut Street - Compton - CA - 90220 - Tel: 310.898.1100 - Fax: 310.898.1107
P36504-A
BELKIN.
www.belkin.com
">
