WA R R A N T Y I N F O R M AT I O N
Owner’s Guide
WA R R A N T Y I N F O R M AT I O N
PUH680
5 YEAR LIMITED WARRANTY
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada)
Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of five years from
the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will repair
or replace this product or any component of the product found to be defective during the warranty period.
Replacement will be made with a new or remanufactured product or component. If the product is no longer available,
replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT
attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable.
Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service
centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and
conditions of this warranty.
This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or
misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly,
repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not
cover: Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or
statutory warranty or condition.
Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a
particular purpose is limited in duration to the duration of the above warranty.
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use
the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of
contract, fundamental or otherwise, or for any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages
or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from province to province,
state to state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A.
If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-333-1930 and a convenient service center address will be provided to you.
In Canada
If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-333-1930 and a convenient service center address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located
in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing
business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any
other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO
NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
1500 Watt Utility
© 2009 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved.
Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
134611/9100020009991
PUH680-U_09EM1.indd 1
PUH68009EM1
Printed In China
Heater
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
3/16/09 9:01:12 AM
P L E A S E R E A D A N D S AV E T H E S E
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. The heater is hot when in use. To avoid burns, DO
NOT let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 ft (0.9 m) from the
front of the heater and keep them away from the
sides and rear.
4. DO NOT run cord under carpeting. DO NOT cover
cord with throw rugs, runners, or the like. Arrange
cord away from traffic area and where it will not be
tripped over.
5. This heater is not intended for use in bathrooms,
laundry areas and similar indoor location. NEVER
locate heater where it may fall into a bathtub or
other water container.
6. Extreme caution is necessary when any heater is
used by, or near children or invalids, and whenever
the heater is left operating and unattended.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and
not the cord.
9. DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
10. DO NOT operate heater with a damaged cord or plug,
or after the heater malfunctions, has been dropped
or damaged in any manner. Return appliance to
manufacturer for examination, electrical or
mechanical adjustment, or repair.
11. A heater has hot and arcing or sparking parts inside.
DO NOT use it in areas where gasoline, paint, or
flammable liquids are used or stored.
12. Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
13. DO NOT use outdoors.
14. To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. DO NOT use on soft surfaces,
like a bed, where openings may become blocked.
15. To disconnect heater, turn controls to OFF, then
remove plug from outlet.
16. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated
not less than 1875 watts.
17. If the heater will not operate, see specific instructions
on Auto Safety Shut-off.
18. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
19. Discontinue use if plug or outlet is hot. It is
recommended that the outlet be replaced if plug or
outlet is hot to touch.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
PUH680-U_09EM1.indd 2
CLEANING / MAINTENANCE
TROUBLESHOOTING
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
OPERATING INSTRUCTIONS
• Amps: 12.5
• Wattage: 1500W (+5% -10%)
• Working voltage: 120V AC/60Hz
1. Place heater on firm level surface.
2. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500
Watts, this unit draws 12.5 Amps.
Mode Settings
ASSEMBLY INSTRUCTIONS
Carefully remove your heater and all parts from the box. 1. To start the heater operation, turn the Thermostat
Control clockwise all the way to the highest.
Ensure all parts are in the package. It is recommended
2. Switch the Selector to your desired heat settings:
save carton for off-season storage.
1 - Low Heat
This package includes:
The heater will run continuously at 1350W.
1 - Heater
2 - High Heat
The heater will run continuously at 1500W.
1 - Carry Handle
3.
The
Power Light will remain lit during operation.
2 - Screws
Thermostat Control
Handle Assembly:
1. You need to turn the Thermostat Control clockwise to
1. Place the heater in upright position.
the highest position to start heater. Allow heater to
2. Use the provided screws to attach the carry handle on
operate and warm up the room.
top of the heater housing (See Figure 1).
2. When the desired temperature/comfort level is
3. Use screw driver to tighten the screws firmly. Please
reached, lower the temperature setting by turning the
ensure that screws are not overtightened.
Thermostat Control counter-clockwise until the heater
NOTE: THIS UNIT IS FOR FLOOR USE ONLY.
stops operating.
3. The thermostat will now automatically maintain the
pre-set temperature level by turning the heater ON
Figure 1
and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to raise the temperature setting.
D
Figure 2
Figure 3
CONTROL PANEL CLOSE-UP
B
TROUBLESHOOTING
Always unplug the heater before cleaning and allow the
heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild
soap and water solution.
2. NEVER use abrasive or flammable solvents to clean
the unit.
3. After cleaning, be sure to completely dry the unit
with a cloth or towel.
4. Store heater in a cool, dry location.
5. It is recommended that you store the unit in its
original carton.
If your heater fails to operate:
• Make sure the electrical outlet or circuit breaker is
working.
• Check for obstructions. If you find an obstruction turn
the heater OFF, and UNPLUG THE UNIT. Carefully
remove the obstruction and follow the reset
instructions.
• The thermostat might be set too low. Turn the
Thermostat Control clockwise until the heater restarts.
• Make sure the Selector is in Low (1) or High (2)
setting.
AUTO SAFETY SHUT-OFF WITH INSTANT
TIP-OVER PROTECTION
This heater is equipped with a Total Safety System with
tip-over protection that will shut-off the heater in an
overheat situation.
Tip-over Shut-off:
When the unit is accidentally knocked over, it will shut
off. To reset, simply place the heater in an upright
position on a level surface.
Overheat Shut-off:
When a potential overheat temperature is reached, the
system will automatically shut the heater off. Make sure
heater is clear of all obstructions. It can only resume
operation when the user resets the unit.
To Reset the Heater:
1. Unplug the heater and wait 30 minutes for the unit
to cool down.
2. After the 30 minutes, plug the unit in again and
operate normally.
3. Place heater on firm level surface.
Please DO NOT attempt to open or repair the
heater.
If you have any questions regarding your product or
would like to learn more about other Patton®
products, please contact our Consumer Service
Department at 1-800-333-1930 or visit our website
at www.pattonproducts.com.
A. Selector/
Power Light
B. Thermostat
Control
C
A. Selector/Power Light
B. Thermostat Control
C. Protective Front Guards
D. Carry Handle
CLEANING/MAINTENANCE
B
A
A
3/16/09 9:01:14 AM
">
