Chest Freezer

Instruction manual

Model

•

CE210-A / CE211-A / CE212-A

*

Safety Tips

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.

• Consult Local and National Standards to comply with the following:

• Health and Safety at Work Legislation

• BS EN Codes of Practice

• Fire Precautions

• IEE Wiring Regulations

• Building Regulations

• DO NOT use jet/pressure washers to clean the appliance.

• DO NOT use the appliance outside.

• DO NOT use this appliance to store medical supplies.

• DO NOT use electrical appliances inside the appliance

(e.g. heaters, ice-cream makers etc.).

• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.

• Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.

• Always switch off and disconnect the power supply to the unit before cleaning.

• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.

• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.

Product Description

CE210-A - POLAR 390 litre Chest Freezer

CE211-A - POLAR 466 litre Chest Freezer

CE212-A - POLAR 598 litre Chest Freezer

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:

• Polar Chest Freezer

• Instruction Manual

POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.

Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

1

*

Installation

Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately

12 hours before operation. If in doubt allow to stand.

1.

2.

3.

Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.

Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.

Set the brakes on the castors to keep the appliance in position

OR

Level the appliance by adjusting the screw feet.

Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:

• Only store foodstuffs in the appliance when it has reached the correct operating temperature.

• Do not place uncovered hot food or liquid inside the appliance.

• Wrap or cover food where possible.

• Avoid opening the doors for prolonged periods of time.

Power Indicator Run Indicator

Turn On

1.

2.

3.

Close the doors/drawers of the appliance.

Turn on the appliance.

Set the thermostat to the desired temperature.

POWER RUN

Thermostat

Defrost

• BUFFALO recommend defrosting the appliance when any frost buld up inside the freezer reaches 5mm thick. To do this switch the freezer off at the power supply.

Cleaning, Care & Maintenance

• Switch off and disconnect from the power supply before cleaning.

• Clean the interior of the appliance as often as possible.

• Do not use abrasive cleaning agents. These can leave harmful residues.

• Clean the door seal with water only.

• Always wipe dry after cleaning.

• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.

• Take care when cleaning the rear of the appliance. Sharp edges can cut.

• A POLAR agent or qualified technician must carry out repairs, if required.

Cleaning the Condenser

Periodically cleaning the condenser can extend the life of the appliance.

2

*

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the Helpline or your POLAR retailer .

The appliance is not working

Fault

The appliance turns on, but the temperature is too high/low

The appliance is leaking water

The appliance is unusually loud

Probable Cause Action

The unit is not switched on

Plug and lead are damaged

Fuse in the plug has blown

Power supply

Internal wiring fault

Too much ice on the evaporator

Condenser blocked with dust

Doors are not shut properly

Appliance is located near a heat source or air flow to the condenser is being interrupted

Ambient temperature is too high

Unsuitable foodstuffs are being stored in the appliance

Appliance is overloaded

The appliance is not properly levelled

The discharge outlet is blocked

Movement of water to the drain is obstructed

The water container is damaged

The drip tray is full

Loose nut/screw

The appliance has not been installed in a level or stable position

Check the unit is plugged in correctly and switched on

Call POLAR agent or qualified Technician

Replace the fuse

Check power supply

Call POLAR agent or qualified Technician

Defrost the appliance

Call POLAR agent or qualified Technician

Check doors are shut and seals are not damaged

Move the refrigerator to a more suitable location

Increase ventilation or move appliance to a cooler position

Remove any excessive hot foodstuffs or blockages to the fan

Reduce the amount of food stored in the appliance

Adjust the screw feet to level the appliance (if applicable)

Clear the discharge outlet

Clear the floor of the appliance (if applicable)

Call POLAR agent or qualified Technician

Empty the drip tray (if applicable)

Check and tighten all nuts and screws

Check installation position and change if necessary

Technical Specifications

Model Voltage

CE210-A 230V 50Hz

CE211-A 230V 50Hz

CE212-A 230V 50Hz

Power Current

230W

230W

230W

1.5A

1.5A

2.3A

Temp

Range

-25 to -18C

-25 to -18C

-25 to -18C

Capacity

(litres)

390

466

598

Refrigerant

R134a 210g

R134a 210g

R134a 210g

Dimensions

H x W x D (mm)

852 x 1330 x 701

830 x 1483 x 701

934 x 1603 x 733

Weight

(Kg)

63

66

85

Electrical Wiring

The plug is to be connected to a suitable mains socket.

POLAR appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L

• Neutral wire (coloured blue) to terminal marked N

• Earth wire (coloured green/yellow) to terminal marked E

All POLAR appliances must be earthed, using a dedicated earthing circuit.

If in doubt consult a qualified electrician.

Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

3

*

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.

POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

POLAR products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.

Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change specifications without notice.

4

DECLARATION OF CONFORMITY

Equipment Type

Model

Legislation

Standards

Producer Name

Producer Address

Chest Freezers

CE210-A, CE211-A, CE212-A

C-Tick

AS/NZ 3820 Essential Safety Requirements for Low Voltage Electrical

Equipment

AS/NZS CISPR 14.1:2010

AS/NZS 60335.2.89:2002 Inc A1-3

POLAR

Unit 2, 34-38 Anzac Ave,

Smeaton Grange,

NSW 2567

I, the undersigned, hereby declare that the equipment specified above conforms to the above Legislation and

Standard(s).

Date 13/11/12

Signature

Full Name Richard Cromwell

•

Notes

•

CE210-A_CE211-A_C212-A_v1