Microdot Microdot, Microdot Xtra Blood Glucose Meter Instructions

microdot
Blood Glucose Monitoring System
To disinfect the Microdot® Meter:
Read the Microdot® Bleach Wipe (EPA Reg. No. 69687-1-88459) label and follow directions for use.
Microdot® Bleach Wipe is for the exterior surfaces of the blood glucose meter and is not for the
use on the needle or the monitor.
1. Always use personal protective equipment as specified on the Microdot® Bleach Wipe label.
2. Thoroughly clean gross filth and heavy soil from surface of Microdot® Meter
to be disinfected.
3. Open Microdot® Bleach Wipe pop-up canister. The wipes are pre-saturated
with a sodium hypochlorite (bleach) hospital-use solution.
Remove a pre-saturated 6” x 6” wipe.
Thoroughly wipe the Microdot® Meter surface to be disinfected.
Allow the Microdot® Meter surface to remain thoroughly wet for 5 minutes.
Then allow the Microdot® Meter surface to air dry.
Dispose of wipe in trash after use. Do not flush wipe in the toilet.
© oo NS Oo DS
Dispose of the non-refillable empty canister according to state and local authorities
as allowed by the Microdot® Bleach Wipe label.
DISINFECTION TIP: __——
In order to maintain 5 minutes of contact time with the
sodium hypochlorite, wrap the MD meter in the wipe
and place meter face down.
“11e D DIFF Spores In ONE STEP In 3 minutes * Kills
microdot
— BLEACH WIPE
HBV & HOY e
III) -
“2 № Cleans e Deodorizes e Kills 99.99% of Germs J
| Sar hn GR 1090 and: guidelines: ol Ie COC 26 8 WW
betuven treated surfaces. eis percal ted vos FO
Protocol to disinfect Microdot® Meter
“sé ALE
| Sa a mb pm a m 5
CAUTION Я
">