Harmar Pinnacle SR601X Stair Lift OWNER'S MANUAL

Below you will find brief information for Stair Lift Pinnacle SR601X. This energy-efficient stair lift is simple to operate, durable, and lightweight. It's designed for easy operation, with a unique patented drive system, wireless remotes, and intuitive operating controls.

PDF
Document
Stair Lift Pinnacle SR601X Owner's Manual | Manualzz

Advertisement

Advertisement

/

Advertisement

Key features

  • Simple to operate

  • Durable

  • Lightweight

  • Patented drive system

  • Wireless remotes

  • Intuitive operating controls

Frequently asked questions

To turn the stair lift on, press the red "ON/OFF" switch located on the top of the chassis to the "ON" position (I) and ensure that the key switch (if equipped) is "ON."

To operate the lift remotely, continuously press the appropriate up or down button on the call/send hand control unit. These hand control units are usually attached to a wall at the upper and lower landings of the staircase.

If your lift does not operate, diagnose the problem by observing the LED indicator light on the armrest and listening to the beeps emitted. A red light indicates a problem that may require a service call. If the light remains red after attempting to reset the lift by turning it "OFF" and then "ON" again, please contact your local dealer or Harmar and describe the problem.

User questions

T M

Linda T.

What steps should be taken if the stair lift green operating light is on but the device will not move?

If the lift fails to move despite the green light indicating operating mode, ensure the following conditions are met:

  1. The seat is in its normal, fully locked position. If swiveled, the lift will prevent movement and may issue a long beep.
  2. The hand control switch (armrest or remote) is continually pressed during operation.
  3. Both armrests are in the down position.
  4. If switching between controls, wait 15 seconds after using the armrest control before attempting to use the remote controls.
Preparing document for printing…
0%