Package Contents:
● 1 x WiFi Repeater ● 1 x Quick Installation Guide
1. Overview
Front View Left View Right View Back View
4
PLDT HOME REPEATER
Wireless-N Repeater
Quick Installation Guide Revision 1.0
www.prolink2u.com
2. Hardware Installation
www.prolink2u.com
Laptop
Router WiFi Range
© Copyright 2014. PROLiNK® All rights reserved.
Smartphone Tablet
Wifi Repeater
Cable / DSL Modem Router
WiFi Repeater Range
Reset
3
WPS
2
1 WPS : Press 1 second to trigger WPS function
2 LED Indicators:
Power : On - Power On
Off - Power Off
WLAN : On - Wireless turn On
Off - Wireless turn Off
WPS : On - WPS feature turn On
Off - WPS feature turn Off
Blinking - WPS triggering
Signal Strength : 1 LED On : Low Signal
2 LEDs On : Medium Signal
3 LEDs On : Good Signal
4 LEDs On : Excellent Signal
Note:
The illustration in this document may appear different from your model.
3 Reset : Press 1 - 5 seconds to reboot Repeater.
Press > 5 seconds to reset to factory default and reboot.
4 AC Power Input www.prolink2u.com
3. Connecting to the Root AP
Method 1 : With WPS button
Step 1. Plug the Wifi Repeater into the electrical socket and power on the electrical socket. The Power
LED on Wifi Repeater will illuminate. Wait until the WLAN and WPS LEDs light
up.
Step 2. Press the Wi-Fi Protected Setup (WPS) button on your wireless router or root AP.
Step 3. Press the WPS button of Wifi Repeater for 1 second until the WPS LED starts to blink.
Note 1. The Signal Strength LEDs will illuminate to show the link quality once connected to the root AP.
Note 2. Both buttons must be pressed within 2 minutes.
LOCATION 1
Wireless Router
WPS
2 seconds
2
Minutes
LOCATION 2
1 second Within 2 Minutes
WPS
WPS
Wifi Repeater www.prolink2u.com
3. Connecting to the Root AP
Method 2 : With Web Configuration
Step 1. Connect your computer to Wifi Repeater via wireless.
The wireless network (SSID) shall appear as “PLDTHOMEREPEATER”.
Note: The Wi-Fi Key or password can be found on the label pasted on Wifi Repeater.
Step 2. Open web browser and type http://192.168.1.253 in the browser’s address box. This is the default IP address for Wifi Repeater.
The default user name is “ admin” and password is “1234”.
3. Connecting to the Root AP
Select the wireless network or root AP that you want to connect to, and click on < Next>.
Step 3. Click on Quick Setup Wizard -> Start
Key in the wireless password of the wireless router or root AP, and click on < Next> to
proceed.
Click < Next>, the repeater will scan and find the available wireless network.
3. Connecting to the Root AP
Important:
Please obtain the wireless password from the owner of the wireless router or root AP.
The repeater will not able to connect to the wireless router or root AP if the password is incorrect.
Check and confirm if the information are correct.
Click < Finish> and the Wifi Repeater will attempt to connect to the root AP.
Note: The Signal Strength LEDs will illuminate to show the link quality once connected to the root AP. www.prolink2u.com
4.
5.
2.
3.
Wireless Password History
1.
www.prolink2u.com
www.prolink2u.com
