advertisement
INSTRUCTION MANUAL
SS1-CV
14
Manual contents
Packing list
OPEN: Mon - Fri 9 AM -6 PM ... Sat 10 AM -3 PM (EST)
Distributed and serviced by: Extreme RC by RSI ... Ferndale, MI 48220
Phone: (586) 757-1336 Email: [email protected]
Website: www.extremercbyrsi.com
MANUFACTURED BY
A NAME YOU CAN TRUST
PACKING LIST
SS1-CV Helicopter
Balance Bar
Main Shaft
Rear Tail Blade
Front Motor
Rear Motor
Tail Motor
Tail
Photo Shoot
Band Selector
Power
Indicator Light
Hover
Throttle
Landing Gear
Infrared Remote Control
Infrared Signal
Micro Memory Card
(other side)
Video Shoot
Fine-Tuning
Turn Left / Right
Left / Right
Forward / Backward Throttle
ON / OFF
Charge Wire
Searchlight
Camera
Charging Socket
Power Switch
Top Main Blade
Bottom Main Blade
Parts Included
Main Blades
Tail Blade
Screwdriver
1
BATTERY INSTALLATION AND CHARGING INSTRUCTIONS
Battery
Installation
Charging
Instructions
1 For Parts, Service and Exciting New Products ...
Check Out Our Website!
www.extremercbyrsi.com
Use screwdriver to open the controller battery cover
2
Insert six 1.5V “AA” Batteries
(not included)
3
For Parts, Service and Exciting New Products ...
Check Out Our Website!
www.extremercbyrsi.com
Secure controller battery cover with screw
Check Out Our Website!
www.extremercbyrsi.com
A
Charge wire
B
USB Charge wire
(1) Turn the helicopter switch “OFF” and the remote control switch “ON”
(2) Plug charge wire into the helicopter. Remote light starts out red, it turns green while charging,
but will turn back to red when the helicopter is fully charged. Full charge takes up to 60 minutes.
(3) Put R/C charge wire back into its storage compartment or
Unplug USB charge wire - put away for safe keeping
(4) Turn helicopter and remote control power switches to the “ON” positions.
NOW YOU’RE READY TO STAR FLYING
Charge time: up to 60 minutes - Flight time: up to 7 minutes
Fresh alkaline batteries strongly recommended
CAMERA INSTRUCTIONS
Camera Adjustment … Camera / Video Undercarriage Lights
Taking Photos
Press the left
“shoulder” button.
undercarriage indicator light will show. Please refer to Camera / Video undercarriage lights section (B).
A
Camera
B
Camera Video ON/OFF lights
Gently aim the camera lens as desired
SS1-CV
CAMERA / VIDEO
Undercarriage photo / video indicator light
One red light blink - photo taken
Solid red light - video is on
Recording Video
Press the right “shoulder” button. To stop recording, push the button again.
undercarriage indicator light will show. Please refer to Camera / Video undercarriage lights section (B).
SS1-CV
CAMERA / VIDEO
INFRARED
PHOT
O
VIDEO
Connect the USB data transfer cable into the back of the helicopter camera. Plug the other end into your computer’s USB port and follow the instructions on your computer screen.
2
Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220 P:(586) 757-1336 E: [email protected]
RELEASE SAFTY
A safty is built into the remote control. To release the safty move the left throttle up down. Safety has been released.
YOU ARE NOW READY TO START FLYING!!
Hover up and down
Learn how to hover (fly in place) first - once you’ve mastered this operation, flying is easy. Once you can hover, try moving up and down with the throttle stick (left). Move the throttle stick gradually.
UP
DOWN
MIDDLE POSITION
SAFTY IS OFF SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
Turn counter clockwise and clockwise
While hovering helicopter, push throttle stick left for
counter-clockwise turns or right for clockwise turns.
Forward
Push the right control throttle up - the nose of the helicopter will point downward, the tail motor will activate, and the helicopter will fly froward.
Reverse
Pull right control throttle down - the nose of the helicopter will point upward, the tail motor will activate, and the helicopter will fly backward.
Calibration control knob
If helicopter rotates counter-clockwise ... turn calibration control knob right until excessive turning stops.
Calibration control knob
If helicopter rotates clockwise ... turn calibration control knob left until excessive turning stops.
Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220 P: (586) 757-1336 E: [email protected]
3
SAFETY INSTRUCTIONS
WARNING
Do not place stickers, weight, or anything else on the helicopter. This may cause the helicopter to crash or malfunction.
Avoid flying the unit under low ceilings. Crashing into ceilings may cause damage to the helicopter.
To avoid injury, do not touch the blades or any other moving parts.
When not in use (especially for 30 days or more) remove ‘AA’ batteries from remote control unit batteries may leak and cause damage.
ENVIRONMENT FOR FLIGHT
Recommended flying area for indoor: 12’L x 12’W x 12’H (3.65 m L x 3.65 m W x 3.65 m H)
Avoid drafts, forced air, water, fans, heat and air conditioning vents.
Keep flying helicopters away from pets, young children, the elderly and the disabled.
USE GOOD COMON SENSE WHEN FLYING!
PARTS LIST:
ALSO AVAILABLE AT WWW.EXTREMERCBYRSI.COM
# 1 Head cover # 2 Main blades # 3 Tail blade # 4 Fuselage housing with bottom outer shaft
# 5 Landing gear
# 6 Balance bar # 7 Tailpipe with motor, fin and tail
# 8 Main inner shaft # 9 Li-poly battery # 10 Side support metal
# 11 Tail support bar # 12 Blade connectors # 13 Center outer shaft # 14 Top shaft center # 15 Top blade connector
# 16 Front motor # 17 Rear motors # 18 Bottom outer shaft # 19 Circuit board with # 20 Camera / video
PARTS - SERVICE - REPAIRS
E-mail: [email protected]
Website: www.extremercbyrsi.com
OPEN: Mon - Fri 9 AM to 6 PM ... Sat 10 AM to 3 PM (EST)
# 21 Photo / Video # 22 Remote control
4
Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220 P: (586) 757-1336 E: [email protected]
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project